Conquer Portable Mechanic Bike User Manual

Product name: PRO Portable Mechanic Bike

F

Repair Stand Bicycle Workstand
SKU: 400-STFLD
EMAIL: [e-mail]
TEL: [phone]

help.conquerequipment.com

Instructions for the Conquer PRO Portable Mechanic Bike Repair Stand

Bicycle Workstand

A. Bicycle clamp
B. Extension tube
C. Tool tray
D. Supporting tube
E. 2 Legs
F. Front wheel stabilizer

B

C

A

D

E

Carefully read the following instructions and understand your repair stand prior to use.
Use this stand only as described in this manual. Please keep these instructions safe
and nearby the stand. Always refer to the documentation for any questions. If you are
unsure of use, contact Conquer.

The stand can only be operated on a level surface and is only intended to be used as a
bicycle repair stand. The load can be no greater than 50 lbs.

Technical specifications:

Maximum load: 50 lbs
The clamp will hold tubes from 30mm to 70mm

EMAIL: [e-mail] WEB: help.conquerequipment.com TEL: [phone]

Product name: PRO Portable Mechanic Bike
Repair Stand Bicycle Workstand
SKU: 400-STFLD
EMAIL: [e-mail]
TEL: [phone]

help.conquerequipment.com

Overview

Ensure the repair stand is on a flat and level surface prior to use.

1. Do not exceed the maximum extension of the bike mounting tube (B).
NOTE: there is a maximum extension mark on the tube.

2. Choose your clamping position on the bike - use the seat post to avoid frame
damage. Try to balance bicycle weight to avoid tipping. It may be best to angle front
wheel toward the ground to balance the bike.

3. For carbon and delicate frames, clamp on the seat post as clamping the frame may
cause damage. If you must clamp the frame, do not clamp on the internal cable housing

4. To stabilize the front wheel, use the front wheel stabilizer (F) between the front wheel
and the extension tube (B). (see fig 1- 1)

fig 1-1

Release the lever (a) on the head to loosen part (b). You can adjust the bicycle clamp in
a full 360 range of motion. (fig 2-1). Lock the clamp lever down to firmly secure the bike
in place. Do not crush bike or over tighten, but ensure it is a snug fit. Ensure the bike is
firmly locked in place prior to use.

(a) (b)

fig 2-1

EMAIL: [e-mail] WEB: help.conquerequipment.com TEL: [phone]