Conquer CQL1621 B User Manual

Instruction Manual (Read before proceeding)

CQL1621-B

Bluetooth Speaker

Power:

z Works on internal rechargeable Lithium battery. Please charge your Bluetooth speaker fully before its first use.
z To charge the battery:

Using a 2-in-1 cable( included):insert the USB power cable into the micro USB port on the speaker. Connect the
other end of the USB cord into a powered USB source such as a computer, laptop or adapter (not included).

z A red light will indicate the charging situation. When battery is full, the red light will turn off automatically.

Playing Music Via Bluetooth

z Turn on Bluetooth speaker by sliding power switch to “On ” position.
z The blue indicator light will flash quickly. This indicates that the speaker is in pairing mode and is searching for

your Bluetooth device.

z Turn on the Bluetooth function on your device, search the speaker named “CQL1621-B’’and select it, your device

will pair without a password. (If required, enter the password “0000” to finalize the paring).The Blue light will
begin to flash slowly after pair is complete.

z Once your speaker is paired, the blue indicator light will begin to flash slower.
z Start playing music on your device. Keep your device within 33feet (10 meters) of your speaker.
z Adjust the volume of your device to a comfortable level.
z Turn off the unit when not in used.

Note: In Bluetooth mode, the speaker will be turned off if which is not paired with Bluetooth device after 5 minutes.

Universal Speaker Operation

z Turn on the unit by pushing the switch on to “ ” position.
z Plug the micro USB cable into the “charging” port and the 3.5mm audio side into the earphone jack on your

device to enjoy music.

z Turn off the unit when not in use.

Caution:

z This is not a toy. Please keep away from small children.
z Please keep away from water / heat.
z Low power may cause poor connection even no working of Bluetooth.
z Do not over-charge the battery.
z Battery pack shall not be exposed to excessive heat such as sunshine, fire or the like

FCC Statement

Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.