Conquer CQL1575 B User Manual

CQL1575-B Bluetooth Speaker

Instruction Manual (Read before proceeding)

Power:

z Works on internal rechargeable Lithium battery. Please charge your speaker fully

before first use. To charge the battery :
Using a Micro USB cable (included), insert the jack into the ”Aux-in Charging” hole
located at the back of the unit and then plug the USB connecter into the USB port on
a computer for charging.

z A red light on the bottom will indicate the charging situation. When battery is full, the

red light will turn off automatically.

Bluetooth Speaker Operation

z Turn on the unit by pushing the switch on the bottom to position. A Blue light on

the bottom will start blinking to indicate the speaker is in paring mode and searching
for your Bluetooth mobile device.

z Open the Bluetooth function on your device and search the speaker named “SB-01”.

After selecting this speaker, your device will pair without a password. (If required,
enter the password “0000” to finalize the paring).The Blue light will begin to flashing
slower after pair is complete.

z Start playing music on your device. Keep your device within 33feet (10meter) of your

speaker.

z Adjust the volume of your device to a comfortable level.
z Turn off the unit when not in used.

Universal Speaker Operation

z For other music devices without Bluetooth, use the attached audio input cable. Insert

the Micro USB jack into the “Aux-in Charging” hole and the 3.5mm jack to the
earphone jack on your device.

z Turn on the unit by pushing the OFF switch on the bottom to “Aux” position and start

playing music.

Caution:

z This is not a toy. Please keep away from children.
z Please keep away from water / heat.
z Low power may cause poor connection even no working of Bluetooth.
z Do not over charge the battery.

FCC Statement

Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.

-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions (1)this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.

