Conquer CQL1567 B User Manual

CQL1567-B Bluetooth Speaker

Instruction Manual (Read before proceeding)

Power:

z Works on internal rechargeable Lithium battery. Please charge your speaker fully

before first use. To charge the battery :
Using a Micro USB cable (included), insert the jack into ”Charging” jack located at the
back of the unit and then plug the USB connecter into the USB port on a computer for
charging.

z A red light aside will indicate the charging situation. When battery is full, the red light

will turn off automatically.

Bluetooth Speaker Operation

z Turn on the unit by pushing the switch at the back. A Blue light aside will start blinking

to indicate the speaker is in paring mode and searching for your Bluetooth mobile
device.

z Bluetooth speaker device name is “SB-02”, connect it via the option menu of your

mobile device, pairing mode is 0000 if any is required. The Blue light will begin to
flashing slowly after pair is complete.

z Start playing music on your device. Keep your device within 33feet (10m) of your

speaker.

z Adjust the volume of your device to a comfortable level.
z Turn off the unit when not in used.

Universal Speaker Operation

z For other music devices without Bluetooth, use the attached audio input cable. Insert

the 3.5 mm jacks into the “Aux-in” jack and into the earphone jack on your device.

z Turn on the unit and start playing music.
z Turn off the unit when not in used.

Caution:

z This is not a toy. Please keep away from small children.
z Please keep away from water / heat.
z Low power may cause poor connection even no working of Bluetooth.
z Do not over charge the battery.

FCC Statement

Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.

-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions (1)this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.

