Conquer CQL1540 B User Manual

CQL1540-B Bluetooth Speaker

Instruction Manual (Read before proceeding)

Power:

z Works on internal rechargeable Lithium battery. Please charge your speaker fully

before first use. To charge the battery :
Using a Micro USB cable (included), insert the jack into the ”Aux-in-Charging” hole
located at the back of the unit and then plug the USB connecter into the USB port on
a computer for charging.

z A red light at the back of the unit will indicate the charging situation. When battery is

full, the red light will turn off automatically.

Bluetooth Speaker Operation

z Turn on the unit by pushing the switch on the back to position. A Blue light at the

back will start blinking to indicate the speaker is in paring mode and searching for
your Bluetooth mobile device.

z Open the Bluetooth function on your device and search the speaker named “JEWEL”.

After selecting this speaker, your device will pair without a password. (If required,
enter the password “0000” to finalize the paring).The Blue light will begin to flashing
slower after pair is complete.

z Start playing music on your device. Keep your device within 33feet (10meter) of your

speaker.

z Adjust the volume of your device to a comfortable level.
z Turn off the unit when not in used.

Universal Speaker Operation

z For other music devices without Bluetooth, use the attached audio input cable. Insert

the Micro USB jack into the “Aux-in Charging” hole and the 3.5mm jack to the
earphone jack on your device.

z Turn on the unit by pushing the OFF switch at the back to “Aux” position and start

playing music.

Caution:

z This is not a toy. Please keep away from small children.
z Please keep away from water / heat.
z Low power may cause poor connection even no working of Bluetooth.
z Do not over charge the battery.











