Conquer CQL1415 B User Manual

CQL1415-B Bluetooth Speaker

Instruction Manual (Read before proceeding)

Power:

z Works on internal rechargeable Lithium battery. Please charge your speaker fully

before first use. To charge the battery :
Using a Micro USB cable (included), insert the jack into the ”Charging” hole and then
plug the USB connecter into the USB port on a computer for charging.

z A red light will indicate the charging situation. When battery is full, the red light will

turn off automatically.

Bluetooth Speaker Operation

z Turn on the unit by switching the “ON OFF” button. A Blue light aside will start

blinking to indicate the speaker is in paring mode and searching for your Bluetooth
mobile device.

z Open the Bluetooth function on your device and search the speaker named “SB-01”.

After selecting this speaker, your device will pair without a password. (If required,
enter the password “0000” to finalize the paring).The Blue light will begin to flash
slowly after pair is complete.

z Start playing music on your device. Keep your device within 33 feet (10 meters) of

your speaker.

z Adjust the volume of your device to a comfortable level.
z Turn off the unit when not in used.

Caution:

z This is not a toy. Please keep away from children.
z Please keep away from water/heat.
z Low power may cause poor connection even no working of Bluetooth.
z Do not overcharge the battery.

FCC Statement



Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.

-- Consult the dealer or an experienced radio/TV technician for help

This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions (1)this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation

The device complies with RF specifications when the device used more than 20 cm away
from your body.