Connects2 CAM-JG1-AD Installation Manual

www.connects2.com

CAM-JG1-AD

Rear View Camera Input and Video In Motion

Application:

Jaguar F-Type 2013 - 2015, XF (XF250) 2012 - 2015,

XJ (XJ351) 2010 - 2015

For Touch Screen Nav Version 3 (Resistive Touch), 3.1 (Capacitive

Touch)

2

ABOUT THIS PRODUCT...

CAM-JG1-AD

Reversing Camera Add-On and Video in Motion Interface for Land Rover touch
screen navigation version 3 systems 2012>. Add on Camera interface allowing you
to add an aftermarket camera to the OEM screen - designed for NTSC cameras
only.

Prior to Installation

Read the manual prior to installation. Technical knowledge is necessary for
installation. The place of installation must be free of moisture and away from heat
sources. Please ensure you use the correct tools to avoid damage to the vehicle or
product.

Connects2 can not be held responsible for the installation of this product.

Technical Support

Connects2 want to provide a fast and suitable resolution should you encounter any
technical issues. With this in mind, when contacting Connects2, try to provide as
much Information as possible. This will speed up the process and help us to help you.

Please use our dedicated online technical support centre: support.connects2.com

Subscribe to our YouTube Channel for installation
guides and tips... www.youtube.com/connects2

www.connects2.comwww.connects2.com

3

FITTING GUIDE

Dipswitch Settings

Vehicle/ navigation Dip 1 Dip 2 Dip 3 Dip 4 Dip 5 Dip 6

Video-in-motion permanent ON ON OFF OFF ON ON

Video-in-motion selective* OFF ON OFF OFF ON ON

* With Dip1 set to “OFF”, the included green cable is used to activate the

video in motion function

Dipswitch Functionality:
Dip 1 – Activation of Video in Motion
Dip 2 – Existing Rear View Camera
Dip 3 – TV icon simulation
Dip 4 – No function
Dip 5 – CAN-bus termination resistor on the vehicle side
Dip 6 – CAN-bus termination resistor on the head-unit side

Setting Dip2 to “ON” codes the factory rear-view camera input, which is located
on the brown fakra male connector of the factory monitor. When reverse gear is
engaged, the navigation will automatically switch to this input.