Conexer DMHD01E User Manual

USER MANUAL

DIGITAL MODULATOR DMHD01E

HD ENCODER DVB-T MODULATOR HDMI LOOP

Congratulations on your purchase of the DMHD01E

This ‘state of the art’ product is a HD encoder with data taken from Video, Audio or HDMI input.
The HDMI input signal is passed to the HDMI output connector.

After compressing the Video into H264 and Audio in AAC or MPEG1-L2, the output is available
as a DVB-T signal.

Standalone conguration is made easy through three tactile switches and ergonomic menus
To make the congurations of the DMHD01E is very simple as special DMHDiFace software is
available for you to download off our website: www.antiference.co.uk

CONTENTS

1 Safety considerations page 1

2 Installation page 3

3 Description of the different elements page 4

4 Setting Up the DMHD01E page 5

4.1 Quick Menu page 5

4.2 Advanced Menu page 6

The DVB settings menu page 6

The AV settings menu page 6

The TS settings menu page 7

5 Programming using a PC page 7

6 Technical specications page 8

7 Declaration of Conformity page 8

1 SAFETY CONSIDERATIONS

1.1 Connecting to the mains supply This product has to be connected to the mains supply.
If there is the slightest doubt concerning the type of connection available on the installation,
please contact your supplier of electricity. Before carrying out maintenance operation or
modication of the installation, the modulator has to be disconnected.
N.B.Only use the supplied power adaptor.

1.2 Overvoltage

An overvoltage on the mains supply can cause short circuits or re. Never overload the power

lines.

1.3 Liquids

This module should be protected from splashes. Please ensure that no containers containing
liquids are placed on this module. Be aware of other persons splashing liquids on the module.

DMHD01E

2

1.4 Cleaning

Disconnect the module before cleaning. Use only a damp cloth and do not use solvents.

1.5 Ventilation

In order to assure an adequate air circulation and to prevent overheating, the ventilation

holes should not be obstructed. The module may not be installed in a hermetically sealed
environment. Other electronic products or heat producing items may not be placed upon or

near the module.

1.6 Accessories

The use of accessories not manufactured by the manufacturer can cause damage to the

module.

1.7 Installation of the module

The module must be installed in a place well protected from direct sunlight.

All measures have to be taken to avoid installation in humid or sunny places.

Do not install near heating elements or other devices producing heat.

Ensure that the module is placed at least 10 cm from other equipment which is susceptible

to electromagnetic radiation. Do not install the module on unstable items, a fall can cause

physical or material damage.

2 - Installation

Please nd a typical connection and installation layout for the DMHD01E.

IR Control

The IR function enables the user to control the source device from a remote location over the

coax cable network. This is achieved with a by-pass distribution amplier such as Antiference
Remotelink or 75 Series Amps and Antiference Magic Eyes (ME200).

3

DMHD01E