Conen WID-DL74 BLP User Manual

Epson P/N V12 H 893020

Conen P/N WID-DL74 BLP

Designed for

®

BrightLink

®

Installation guide

For workITdesk interactive
table for

®

BrightLink

®

Mounting the table unit

1

Unpack boxes 1 of 4 (Mobile base) and 2 of 4 (Motorized
center column) and attach base to column using the
4 x M8 x 40 (1/3" x 1.6") Allen screws + 4 washers.

2

Unpack box 3 of 4 (Board frame w. tilt actuator) and attach
frame to column using the 4 x M8 x 40 (1/3" x 1.6") Allen
screws + 4 washers.

3 4

Unpack box 4 of 4 (50" x 67" table top) and hang the
board onto the frame.

Secure the board
to the frame
using the 4 x M6 x
70 (0.23" x 2.75")
Allen head
screws.

They need to be
inserted in the
outer most holes
on top and bot­tom of the frame.

Make sure to run the two cables exiting the column through
the cut out of the board frame before securing the 4 bolts.

Release the two bolts on the brackets on the back of
the board and slide in the projector arm to its lowest
position. Secure the arm by tightening the bolts on
both top and bottom bracket.

6.5"

2

Attach Control Pad & Finger Touch Unit and feed cables
(parts supplied with projector)

5 6

Attach the finger touch module with 2 x Phillips head
screws (0.14" x 1.4") to the board surface at approx. 7"
from top of the board.

7 8

Feed the cable, which links FTU to the projector, through
the opening in the board and plug in the connector.

Attach touch panel with 4 x Phillips head screws
(0.165" x 0.63").

Plug in both cables into the Control Pad (AC Power Cable
Cat6 network cable (not included) USB-B cable (not
included).

9

Feed all cables to the projector
through the projector arm (from
bottom to top of the arm).

Secure the AC adapter bracket with 4 x Phillips head screws (0.16" x 0.63") to the back
of the board. Slide in the adapter.

workITdesk interactive table

3