Condux Adjustable Manhole Adapter User Manual

Limited Warranty

USER GUIDE USER GUIDE USER GUIDE

Adjustable Manhole Adapter

© Copyright 2012, Condux International, Inc.

Condux International, Incorporated extends the following warranty to the original purchaser of
these goods for use, subject to the qualifications indicated:

Condux International, Incorporated warrants to the original purchaser for use that the goods or
any component thereof manufactured by Condux International will be free from defects in
workmanship for a period of 1 year from the date of purchase, provided such goods are
installed, maintained, and used in accordance with Condux written instructions.

Components not manufactured by Condux International but used within the assembly provided
by Condux International are subject to the warranty period as specified by the individual
manufacturer of said component, provided such goods are installed, maintained, and used in
accordance with Condux’s and the original manufacturer’s written instructions.

Condux’s sole liability and the purchaser’s sole remedy for a failure of goods under this limited
warranty, and for any and all claims arising out of the purchase and use of the goods, shall be
limited to the repair or replacement of the goods that do not conform to this warranty.

To obtain repair or replacement service under the limited warranty, the purchaser must contact
the factory for a Return Material Authorization (RMA). Once obtained, send the RMA along
with the defective part or goods, transportation prepaid to

Condux International, Inc.
145 Kingswood Drive
Mankato, MN 56001

THERE ARE NO EXPRESS WARRANTIES COVERING THESE GOODS OTHER
THAN AS SET FORTH ABOVE. THE IMPLIED WARRANTIES OR
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE
LIMITED IN DURATION TO ONE YEAR FROM DATE OF PURCHASE.

CONDUX ASSUMES NO LIABILITY IN
CONNECTION WITH THE INSTALLATION OR
USE OF THIS PRODUCTEXPECT AS STATED IN
THIS LIMITED WARRANTY. CONDUX WILL IN
NO EVENT BE LIABLE FOR INCIDENTAL OR
CONSEQUENTIAL DAMAGES.

Printed in USA
Literature Part Number, 08674769
Revision Number 1.1

1. Place the adapter over the manhole..

!WARNING: Read and understand all procedure and

 Manhole adapter comes standard with 4” plate

Note

Set up Procedure Parts List

!WARNING

 6” adapter plate is available (P/N 08674752)

Setup Procedure

1. Place adapter over the manhole

2. Loosen knobs and slide movable out until they contact
the manholes edge

3. Tighten knobs

4. Slide plate to center over the pull

5. Position retaining fork over tube and secure thumb
screws

6. Maneuver the cable glider cable puller so the its front
pivoting arm rests in the retaining fork

2. Unscrew the knobs and adjust the stops until they contact the
manhole’s edge.

safety instructions before replacing any Condux Swivel

3. Retighten the knobs after adjustments.

Break Pin. Failure to do so may result in personal injury
or property damage. Save this user’s guide for future

4. Position the fork over the center tube and secure it with the

reference.

thumb screws.

*Comes standard with 4-inch adapter plate
*6” adapter plate available

: Read and understand all
procedure and safety instructions before using
the Condux Adjustable Manhole Adapter.
Failure to do so may result in personal injury or
property damage. Save this user’s guide for
future reference.