Condoplex Monitoring Systems UMWWS Users Manual

UM-WWS

Water Sensor

Identifying the Parts:

1. Antenna

2. Learn I Test Button

3. Probe (Water Detection)

4. Battery Lid

5. Buzzer

4

Accessories:

1 Probe cable
1 Set of mounting screws
1 Battery

Getting Started

• Remove battery lid by sliding it in the direction of the

arrow on the bottom of the water sensor.

• Pull battery clip out and connect to battery then re-insert

into the water sensor.

Page 1

1

5

2

3

Detailed Programming and Setup Instructions:

• Place the Receiving Device into Learning Mode (see

instruction for your particular receiving device).

• Then press the Red Button on the Water Sensor being

learned. The Receiving Device will provide an
audible and/or visual indication of code acceptance.

• While the Receiving Device is still in Learning Mode,

repeat the above with each Water Sensor to be
programmed.

• Positioning the Water Sensor in place on a level

surface or wall Mount using the provided screws.

• Use Probe Extender to (1) monitor hard-to-reach

places.

• (2) Water Sensor must be placed high-up off the floor,

or (3) when a pad is required to cover a larger radius
space.

• To activate the extender, insert Probe Extender plug

into the socket on the Water Sensor's and mount using
the screws provided

Normal Operation:

.

. When the probe touches water, the sensor will sound an alarm

and send a signal to a receiving device. Sensor will continue
alert until the probe is dry. Sensor can be reset or alarm
silenced by pressing the Red Button.

Page 2