Condoplex Monitoring Systems TX1 2 User Manual

User Manual for the Tx Series Transmitters

ITPA

The TX series transmitters GX1002SM,GX1002CSM,GX1004SM,GX1004CSM,CDTX1SM,TX1SM,TX2SM
(Mother board：ITPA) are extremely easy to use. The following will explain each of the button functions of the
transmitter. The T1 Module has 4 physical buttons. The Tx2 uses the same PCB hardware and firmware components
but has only two functional buttons.

(TX1SM ONLY)

(TX1SM ONLY)

The TX series transmitters GX1002, GX1002C, GX1004, GX1004C, CD-TX-1, TX-1, TX2(Mother board:IT9B) are
extremely easy to use. The following will explain each of the button functions of the transmitter. The T1
Module has 4 physical buttons. The Tx2 uses the same PCB hardware and firmware components but has
only two functional buttons.

Button 1 :Arm/Disarm (TX1 ONLY)

Pressing this button for 1 second will indicate to your receiver to arm your home panel. Pressing this
button again will indicate that you wish to disarm your panel.

Button 2: Panic (TX1 ONLY)

Press this button for 1 second to send a panic signal to your home security panel or receiver located
somewhere in the facility.

Button 3: Garage/Door

Pressing this button for 1 second will indicate to your receiver to send an open garage door signal to your
receiver.

Button 4: Medic Alert

Press this button for 1 second to send a Med ic Alert signal to your home security panel or receiver
located somewhere in the facility.

Your transmitter also has the capability to send a battery low condition to your receiver unit. This signal
will be generated when pressing any of the 4 transmitter buttons.

1

Declarations

This device complies with FCC Rules Part 15 Operation & Industry Canada licence-exempt
RSS standard(s) is subject to the following two conditions:

(1) This device may not cause harmful interference and
(2) This device must accept any interference that may be received, including interference that

may cause undesired operation of the device.

Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio Exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil neDoit pas produire de brouillage, et(2) l'utilisateur de l'appareil doit accepter tout
brouillage Radioélectrique subi, meme si le brouillage est susceptible d'en compromettre le
fonctionnement.

NOTE: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user's
authority to operate the equipment

If you have any other questions concerning the operation of your transmitter, please send these questions
to the address below care of Technical Support.

Condoplex Monitoring Systems, Inc.
75 Horner Avenue, Unit #7
Etobicoke, ON
M8Z 4X5

2