Condeco TIX6 GW User Manual

Condeco Sense Gateway

User Manual and Configuration

Page 2 of 11

Condeco Sense

Contents

Overview............................................................................................................................. 3

Accessing the Gateway UI ................................................................................................... 4

Network Configuration ....................................................................................................... 5

Condeco Network Settings ............................................................................................. 5

Provisioning Certificates for the VPN tunnel ................................................................... 6

Updating time and date .................................................................................................. 6

Condeco System Settings ................................................................................................... 8

Sense Network Settings ................................................................................................. 8

Condeco Sense Discovery ................................................................................................... 9

Condeco Sense Management ............................................................................................. 9

Condeco Status ................................................................................................................. 10

De-installation ................................................................................................................... 11

Page 3 of 11

Condeco Sense

Overview

This guide will run through the basic configuration steps needed to implement a gateway
for a sense installation. This focuses on setting a network connection using 3G, although
you will have the option to set up a connection via LAN and Wifi.

To set a 3G connection, you will be required to insert a sim card onto the PCB. You will be
required to remove the gateway casing. Make sure the gateway is not powered when
exposing the PCB to insert the sim card.

Page 4 of 11

Condeco Sense

Accessing the Gateway UI

The gateways are configured with this static address.

To access to UI run through the follow.

1) Power the gateway on and connect to a laptop/PC using a network cable.

2) On the Local Area Connection, open the properties for the Internet Protocol

Version 4 (TCP/IPv4)

3) Set the Static address as

4) Save and close.

5) Open IE or Crome and browse to http://192.168.1.1:10000

6) Once you browse to the link above, you will reach the login to Webmin page. Use

these credentials and select Login.

 Username: condeco
 Password: c0nd3c0gw