Concrobium 625001 User Manual

Date Printed: 9/19/2019

Safety Data Sheet

* Trusted Quality Since 1921 *

www.rustoleum.com

1. Identification

Product Name: CC 128OZ 4PK MOLD CONTROL PRO Revision Date: 9/19/2019

Product Identifier: 625001 Supercedes Date: 9/18/2019

Recommended Use: Biocidal Products

Page 1 / 5

Supplier:

Preparer: Regulatory Department

Emergency Telephone:

Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, IL 60061
USA

Siamons International, Inc.
48 Galaxy Blvd., Unit 413
Toronto, ON M9W 6C8
Canada
Phone: [phone]
Toll Free: 1-866-811-4148

24 Hour Hotline: [phone]

Manufacturer:

2. Hazard Identification

Classification

Symbol(s) of Product

No symbol is required per 2012 OSHA Hazard Communication Standard 29 CFR 1910.1200.

Signal Word

No Signal Word has been assigned.

Possible Hazards

1% of the mixture consists of ingredient(s) of unknown acute toxicity.

Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, IL 60061
USA

Siamons International, Inc.
48 Galaxy Blvd., Unit 413
Toronto, ON M9W 6C8
Canada
Phone: [phone]
Toll Free: 1-866-811-4148

3. Composition / Information On Ingredients

HAZARDOUS SUBSTANCES

Chemical Name CAS-No. Wt.% Range GHS Symbols

Trisodium phosphate 7601-54-9 1.0-2.5 GHS06 H311-332

GHS Statements

4. First-Aid Measures

FIRST AID - EYE CONTACT: Immediately flush eyes with plenty of water for at least 15 minutes holding eyelids open. Get medical

attention. Do NOT allow rubbing of eyes or keeping eyes closed.

FIRST AID - SKIN CONTACT: Wash skin with soap and water. Remove contaminated clothing. Get medical attention if irritation
develops or persists.

Date Printed: 9/19/2019

FIRST AID - INHALATION: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get
immediate medical attention. Do NOT use mouth-to-mouth resuscitation. If you experience difficulty in breathing, leave the area to
obtain fresh air. If continued difficulty is experienced, get medical assistance immediately.

FIRST AID - INGESTION: Swallowing less than an ounce will not cause significant harm. For larger amounts, do not induce vomiting,
but give one or two glasses of water to drink and get medical attention. If swallowed, rinse mouth with water. If feeling unwell, get
medical attention.

Page 2 / 5

5. Fire-Fighting Measures

EXTINGUISHING MEDIA: None Known

UNUSUAL FIRE AND EXPLOSION HAZARDS: No unusual fire or explosion hazards noted. Keep containers tightly closed. FLASH

POINT IS TESTED TO BE GREATER THAN 200 DEGREES F.

SPECIAL FIREFIGHTING PROCEDURES: Water may be used to cool closed containers to prevent buildup of steam. If water is
used, fog nozzles are preferred.

Special Fire and Explosion Hazard (Combustible Dust): No Information

6. Accidental Release Measures

STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: If spilled, contain spilled material and remove with inert

absorbent. Dispose of contaminated absorbent, container, and unused contents in accordance with local, state, and federal
regulations. Do not incinerate closed containers

7. Handling and Storage

HANDLING: Wash thoroughly after handling. Wash hands before eating. Remove contaminated clothing and launder before reuse.

Use only with adequate ventilation. Follow all SDS and label precautions even after container is emptied because it may retain
product residues. Avoid breathing fumes, vapors, or mist. Avoid contact with eyes, skin and clothing.

STORAGE: Store in a dry, well ventilated place. Keep container tightly closed when not in use.
Advice on Safe Handling of Combustible Dust: No Information

8. Exposure Controls / Personal Protection

Chemical Name CAS-No.

Trisodium phosphate 7601-54-9 5.0 N.E. N.E. N.E. N.E.

PERSONAL PROTECTION

ENGINEERING CONTROLS: Use process enclosures, local exhaust ventilation, or other engineering controls to control airborne

levels below recommended exposure limits. Prevent build-up of vapors by opening all doors and windows to achieve cross-ventilation.

RESPIRATORY PROTECTION: A respiratory protection program that meets OSHA 1910.134 and ANSI Z88.2 requirements must be
followed whenever workplace conditions warrant a respirator's use.

SKIN PROTECTION: Use gloves to prevent prolonged skin contact. Nitrile or Neoprene gloves may afford adequate skin protection.

EYE PROTECTION: Use safety eyewear designed to protect against splash of liquids.

OTHER PROTECTIVE EQUIPMENT: Refer to safety supervisor or industrial hygienist for further guidance regarding types of personal

protective equipment and their applications.

HYGIENIC PRACTICES: Wash thoroughly with soap and water before eating, drinking or smoking. Remove contaminated clothing
immediately and launder before reuse.

Engineering Measures for Combustible Dust: No Information

Weight %

Less Than

ACGIH TLV-

TWA

ACGIH TLV-

STEL

OSHA PEL-TWA

OSHA PEL-

CEILING