Conair WW35D, WW33D User Manual
Instructions
for use of
Weight Watchers
Body Fat Analysis
bathroom scales
Congratulations! By purchasing this Weight Watchers Scale, you’ve made the
first step toward taking control of your weight. To get the greatest benefit from
your purchase, please read this entire brochure before using your scale.
Scales by
™
Models #WW33D, WW35D
*Heshka S, et al. Weight loss with self-help compared to a structured commercial program: a randomized controlled trial.
JAMA 289(14): 1792, 2003
©2006 Conair Corporation. East Windsor, NJ 08520, Glendale, AZ 85307, Made in China
©2006 Weight Watchers International Inc. All rights reserved. Weight Watchers is the
registered trademark of Weight Watchers International Inc. and used under license.
When You’re Maintaining Weight
Fluctuations in day-to-day weight tend to be smaller when weight is stable, so a
more frequent weigh-in pattern is helpful. To maintain a stable weight:
• Weigh yourself more often than once a week.
• Use the “5-pound rule” – research shows that people who keep weight within
a 5-pound range are more likely to maintain a healthy body weight over the
long term.
Weight And Body Fat
How does it work?
While body fat can be measured in many ways, the method used in your scale is
bioelectrical impedance. This indirect method of determining body fat starts when a
safe and very low electrical current is sent through the lower half of the body. The
electrical current flows more quickly through water and muscle than it will through
bone and fat. The scale measures the speed of the current. Based on this number,
the scale estimates body fat using a multi-step, mathematical formula.
Is it accurate?
Measurements of body fat tend to fluctuate a lot more than simple weighing, and
different methods of estimating body fat yield very different results. Just as different
scales give different results, different body fat analyzers can provide very different
body fat estimates. Even with the same scale the numbers will vary because:
• Weight loss tends to produce substantial, continuous, and unpredictable changes
in body water content. Because body fat analysis is determined by water content
in the body, results can vary considerably from day to day.
• Hydration status affects body fat results. If you’ve just worked out, there is less
water for the electrical current to flow through. This may result in a higher body
fat result. In the same way, if you measure your body fat after drinking a lot of
fluid, it may appear that body fat is lower than it really is.
• Skin temperature can have an influence also. Measuring body fat in warm humid
weather when skin is moist will yield a different result than if skin is cold and dry.
• As with weight, it is better to track trends over time than to use individual daily
results, when your goal is to change body composition.
• Results may not be accurate for persons under the age of 16, or persons with an
elevated body temperature, diabetes or other health conditions.
What you need to know!
• Percent body fat refers to the number of pounds of fat divided by your total body
weight and multiplied by 100.
• During weight loss, percent body fat doesn’t appear to be reduced as quickly as
expected because total weight loss and total body fat are decreasing at the same
time (for a more detailed explanation, see next section).
• Weight loss in the form of body fat and lean tissue (muscle) is common, and is normal.
• To minimize the loss of lean tissue, include regular physical activity, especially
strength training, in your weight loss plan.
Why do I lose weight but my body fat doesn’t change much?
• Remember that your Weight Watchers body fat monitor is showing your body fat
as a percentage, not as an absolute number of pounds. At the beginning of
a weight loss program, a person may weigh 200 lbs and show 30% body fat,
equaling 60 lbs of fat (30% of 200 lbs = 60 lbs). A few weeks later, the same
person may have lost a substantial amount of weight. Weight is now at 180 lbs,
yet body fat is still at 30%. Why? Did that person not lose any fat? Yes, they did.
At 180 lbs with 30% body fat, the person now has 54 lbs of body fat (30% of
180 lbs = 54 lbs), meaning that 6 lbs of the total 20 lbs lost were fat. So, do not
be overly concerned if your body fat % does not change despite the fact that you
are losing weight. Remember, to minimize the loss of lean tissue include regular
physical activity, especially strength training, in your weight loss plan.
Make the most of it!
To summarize, make the most of the body fat analysis feature by:
• Tracking change over time and not day to day.
• Using the same scale as much as possible.
• Being extra-consistent in the time of day, day of the week, time before or after
food and fluid consumption, before or after exercise, etc., when measuring body
fat composition.
Always keep in mind that you know your body best. The following ranges
of Body Fat Percentages are offered as guides:
Healthy Range
of Body Fat
Percentage
While a scale/body fat monitor can be a useful tool on your weight-loss
journey, it’s not in and of itself a program for losing weight. Studies show
that people lose three times more weight on Weight Watchers than they
do on their own*.
Come to a meeting and learn from us the best way to lose and maintain
weight. Call 1-800-651-6000 or go to WeightWatchers.com to find a
meeting near you.
Service Centers:
Conair Corporation
Service Department
150 Milford Road
East Windsor, NJ 08520
Conair Corporation
Service Department
7475 N. Glen Harbor Blvd.
Glendale, AZ 85307
1-800-326-6247
www.conair.com
Age Females Males
18-39 21-32% 8-19%
40-59 23-33% 11-21%
60-79 24-35% 13-24%
06AD15148
IB-7399
Important Information Concerning Weight Management:
Your scale is the best tool for monitoring weight. While not the only measure of
weight loss, scales are the most popular method used to gauge weight-loss
success. A scale measures the sum of your total body weight, which includes bone,
muscle, fat, and water.
Body weight fluctuates during the day, and from day to day, depending on
a variety of factors.
• Salt and carbohydrate intake can affect the body’s water retention.
• A large meal adds weight and can cause water retention.
• Dehydration from exercise, illness, or low fluid intake can result in weight loss.
• Muscle is also a factor. Heavy-duty resistance training can build muscle, which
can affect weight.
• The menstrual cycle can cause temporary weight gains and losses.
When You’re Losing Weight
It’s important not to put too much stock in the exact number on the scale,
because it can and will vary. This is especially true when you’re dieting. Small
weight gains and losses are common as your body adjusts to fewer calories and
more exercise. Your scale is a valuable tool when used to track weight over a
period of weeks and months. Be aware that different scales often give different
results. The scale at your doctor’s office may show one weight, and your scale at
home another. So don’t get too caught up with a single number.
Don’t Overdo It!
A surefire way to get overly concerned with your weight is to weigh yourself too
often. Weigh yourself no more than once a week when you’re dieting. Though
it’s hard to stick to this pattern, it’s the best way to prevent unnecessary concern
with normal weight fluctuations, which are unrelated to your weight-loss efforts.
Regardless of your weighing habits, it’s important that you’re consistent.
Here are 5 rules for effectively monitoring your weight – weigh yourself:
To keep track of your weight, record only one number for the week.
This will give you a clear picture of any trend your weight is following.
If you would like to confirm whether your area is participating, call 1-800-651-6000
Map of participating areas
Using The Weight-Only Mode
For weight-only mode, no personal data entry is necessary.
1. Place scale on a flat, level surface.
2. Tap center of scale platform with foot to activate (display will flash).
3. Wait for "0.0" to appear in display window.
4. Step onto scale. Weight measurement will appear in display window.
Facts You Should Know
Your Weight Watchers scale is a precise measuring instrument that is most
accurate when weighing a stationary object. To ensure the most accurate readings
always try to stand on the same area of the scale platform and DO NOT MOVE.
Should the weight on the scale exceed the scale’s capacity, you may see an error
message ”ERR”.
Electronic sensors are sensitive. Be careful not to drop or jar the scale. Place it
gently onto floor surface, and store where it will be protected from impact. The
scale is an electronic instrument and should never be submerged in water. Clean
with damp cloth and/or glass cleaner.
In the unlikely event that the scale battery malfunctions and needs to be replaced,
lift the battery cover on the bottom of the scale and replace the old battery with
a 3V lithium battery (CR2032). Dispose of the old battery properly. Do not
attempt to open the scale or to remove any components. Servicing should
be done by qualified technicians only. See warranty information below.
LIMITED TEN YEAR WARRANTY
Conair will repair or replace, at our option, your appliance free of charge for
120 months from the date of purchase if the appliance is defective in
workmanship or materials.
To obtain service under this warranty, return the defective product to the service
center listed below that is nearest you, together with your sales slip and $5.00 for
postage and handling. California residents need only provide proof of purchase
and should call 1-800-3-CONAIR for shipping instructions. In the absence of a
receipt, the warranty period shall be 120 months from the date of manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS, OR LIABILITIES, INCLUDING BUT NOT
LIMITED TO THE IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR
A PARTICULAR PURPOSE, SHALL BE LIMITED IN DURATION TO THE 120 MONTH
DURATION OF THIS WARRANTY. Some states do not allow limitations on how long
an implied warranty lasts, so the above limitations may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY,
EXPRESS OR IMPLIED, WHATSOEVER. Some states do not allow the exclusion or
limitation of special, incidental, or consequential damages, so the above limitation
may not apply to you. This warranty gives you specific legal rights, and you may
also have other rights which vary from state to state.
Before Using Scale
1. Remove all packaging materials.
2. Set switch on the base of scale to measure in kg (kilograms) or lb (pounds).
3. Set scale on floor. Surface must be level for accurate operation and safety.
Customizing Your
Weight Watchers® Body Fat Monitor
1. Tap center of scale platform with foot to activate digital display (display will flash).
2. Wait for "0.0" to appear in display window.
3. You are now ready to input your personal data. Firmly press the SET button
located next to the display.
Enter User Number
• P-01 will flash in display window.
• Press UP or DOWN arrows to select your individual
user number.
• When selected user number appears in display, press SET
button to save user number.
• The scale is now ready for you to enter your height.
Set Height
• "Ht" (height) will flash in display window.
• Press UP or DOWN arrows to scroll to your height measurement.
• Press SET button to save height.
• The scale is now ready for you to enter your age.
Set Age
• "Age" will flash in display window.
• Press UP or DOWN arrows to scroll to your age.
• Press SET button to save age.
• The scale is now ready for you to enter your gender.
Set Gender
• The gender icons will flash in display window.
• Press UP or DOWN arrows to select male or female icon.
• Press SET button to save gender.
• The scale is now ready for you to weigh yourself and to
determine percentage of body fat.
Using Your Weight Watchers® Body Fat Monitor
Precautions for Use
CAUTION! Use of this device by persons with any electrical implant such as
a heart pacemaker, or by pregnant women, is not recommended.
1. Tap center of scale platform with foot to activate digital display (display will flash).
2. Wait for "0.0" to appear in display window.
3. Firmly press the USER button located below the display several times until your
user number appears. Note: The scale will automatically scroll through your
customized data, then 0.0 will be displayed.
4. Step onto the scale BAREFOOT, making sure the balls of your feet cover
both metal plates.
5. Weight will be displayed for several seconds. Remain on scale without moving!
6. Display will then flash "bf", followed by your body fat percentage.
• Once a week, on the same day of
the week
• At the same time of day
• In the same place
• Wearing the same clothes
• Using the same scale
Loading...