Conair SB1C Instruction Manual

IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, especially when children are present, basic safety pre­cautions should always be followed, includ­ing the following:
READ ALL INSTRUCTIONS
BEFORE USING
KEEP AWAY FROM WATER
DANGER Any hair dryer is elec-
trically live even when the switch is off. To reduce the risk of death or injury by elec­tric shock:
1. Always “unplug it” immediately after using.
2. Do not use while bathing or in a shower.
3. Do not place or store appliance where it can fall or be pulled into a tub or sink.
4. Do not place in, or drop into, water or other liquid.
5. If an appliance falls into water, “unplug it” immediately. Do not reach into the water.
WARNING
To reduce the risk of
burns, electrocution, fire, or injury to persons:
1. This appliance should never be left unattended when plugged in.
2. This appliance should not be used by, on, or near children or individuals with certain disabilities.
3. Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer.
4. Never operate this appliance if it has a dam­aged cord or plug, if it is not working properly, if it has been dropped, damaged, or dropped into water. Return the appliance to a Conair Service Centre for examination and repair.
5. Keep the cord away from heated surfaces.
Do not pull, twist, or wrap line cord around dryer, even during storage.
6. Never block the air openings of the appliance or place it on a soft surface, such as a bed or couch, where the air openings may be blocked. Keep the air openings free of lint, hair, and the like.
7. Never use while sleeping.
8. Never drop or insert any object into any opening or hose.
9. Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
10. Do not use an extension cord to operate dryer.
11. Do not direct hot air toward eyes or other heat-sensitive areas.
12. Attachments may be hot during use. Allow them to cool before handling.
13. Do not place appliance on any surface while it is operating.
14. While using the appliance, keep your hair out of it. Keep your hair away from the air inlets.
15. Do not use with voltage converter.
SAVE THESE
INSTRUCTIONS
LES PIÈCES DU SÉCHOIR
compact for storage inside the housing.
GET TO KNOW
Gently loop powercord and store it in the housing as well. Make sure prongs on power plug do not damage bonnet or hose.
10. Dryer stands up on its side for space-sav­ing storage.
11. In the unlikely event that the dryer shuts off during use, please check the inlet grill for lint build-up and clean if necessary.
YOUR HAIR DRYER
4 Heat Settings for Maximum Styling
On/Off Switch
Hot Air Vent Brush
OPERATING
INSTRUCTIONS
This appliance is intended for household use only. Use on Alternating Current (60 hertz) only. Standard Dryers are designed to oper­ate at 110 to 125 volts A.C.
This appliance has a polarized plug (one blade is wider than the other). As a safety fea­ture, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.
HOW TO SET UP AND USE
YOUR SOFT BONNET DRYER
1. Open the door on the side panel of the Soft Bonnet Dryer. Pull out the line cord, the hose and the bonnet.
2. To fully extend the hose, press the release button on the hose to loosen the locking mechanism.
3. Attach the bonnet to the hose by lining up the protrusions in the hose locking ring with the indentations in the bonnet locking ring. Twist slightly to lock.
4. Place Soft Bonnet Dryer flat (not standing up like a purse) on table or countertop. Connect power cord to outlet.
5. Place bonnet over hair, pull drawstring comfortably tight and lock in by pushing locking mechanism button and sliding close to the metal ring in the bonnet.
6. Turn Soft Bonnet Dryer on. High setting is best for very wet hair; medium and low set­tings are for more gentle drying or touch-ups on hair that has been lightly misted with water. Drying times vary with heat settings and different hair types; you will soon learn which heat setting and timing works best for your hair. For best curl results, turn the dryer to the "cool" setting for a few minutes at the end of your drying time. Cool air sets curls for long-lasting results.
7. To use concentrator or vent brush for pre­cision drying and styling, unlock the bonnet from the hose and attach the concentrator or vent brush by lining up the lines on the lock­ing rings of hose and attachment. Slightly twist clockwise to lock. Use the concentrator as you would use a concentrator on a regular hair dryer and use the vent brush for preci­sion styling.
8. For hot conditioning treatments, follow the directions of the treatment manufacturer. Generally, the conditioning lotion or liquid is distributed in the hair and heat is applied until the desired conditioning has been achieved.
9. After use of bonnet, push the locking mechanism button again and pull away from the bonnet to unlock the drawstring. Take bonnet off and unlock it from the hose. Let bonnet and hose cool down for a few minutes until they are no longer warm to the touch. Then fold the bonnet and store it in the dryer housing. Push in the easy lock button on the hose while at the same time pulling the draw­string: the springy hose will conveniently
6. Mettez le séchoir en marche. Le réglage
élevé convient mieux pour les cheveux très
flexible se comprime pour le rangement dans
le coffret. Enroulez le fil et insérez-le aussi
GET TO KNOW
YOUR HAIR DRYER
On/Off Switch
6' Power Cord
Limited Two Year Warranty
4 Heat Settings for Maximum Styling
Compact Storage Case with Handle
Hot Air Vent Brush
4' Hose with Easy Lock Feature
Soft Bonnet with Easy Lock Feature
Concentrator Nozzle
CONSIGNES
4. N’utilisez jamais un appareil dont le fil
ou la fiche est endommagée, qui ne
Loading...