Conair RB70 User Manual

THE

BLENDOR

PROFESSIONAL FOOD

AND BEVERAGE BLENDER

RB70

For your safety and continued enjoyment of this product,

always read the instruction book carefully before using.

TABLE OF CONTENTS

Important Safeguards . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1

Grounding Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3

Important: Hot Blending Instructions . . . . . . . . . . . . . . . . . . . . .3

Operating Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4

How To Clean Containers With Nonremovable Blades . . . . . . .5

How To Clean Unit Base . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5

Recipes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5

IMPORTANT: Always unplug the Waring®Blendor from outlet when disassembling and assembling.

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should always be followed, including the following.

READ ALL INSTRUCTIONS.

2. To protect against risk of electrical shock, do not put appliance in water or other liquid.

3. Close supervision is necessary when any appliance is used by or near children.

4. Unplug from outlet when not in use, before putting on or taking off parts, and before cleaning.

5. Avoid contacting moving parts.

6. Do not operate the Waring

Blendor or any other electrical equipment with a damaged cord or plug, or after the unit malfunctions, or is dropped or damaged in any manner. Return it to the nearest authorized service facility for examination, repair, or adjustment.

7. The use of attachments, including canning jars, not recommended or sold by Waring may cause fire, electric shock, or injury.

8. Do not use outdoors.

9. Do not let cord hang over edge of table or counter, or touch hot surfaces.

10. Keep hands and utensils out of jar while blending to prevent the possibility of severe personal injury and/or damage to the blender. A rubber spatula may be used, but must be used only when the blender is not running.

11. Blades are sharp. Handle carefully.

12. To avoid injury, never place blade assembly on the base without container properly attached.

13. Always operate blender with cover in place.

14. When blending hot liquids, remove center piece of two-piece cover. Limit amount of material blended to

⁄2 cups (12 oz.). Always begin blending at the lowest

1 speed setting. Keep hands and other exposed skin away from the lid opening to prevent possible burns. See Hot Blending instructions, next page.

15. Do not leave blender unattended while it is running.

SAVE THESE INSTRUCTIONS

GROUNDING INSTRUCTIONS

For your protection, Waring®Blendors are equipped with a 3-conductor cordset that has a molded 3-prong grounding-type plug, and should be used in combination with a properly connected grounding-type outlet as shown in Figure A. If a grounding-type outlet is not available, an adapter, shown in Figure B, may be obtained so that a 2-slot wall outlet can be used with a 3-prong plug. As in Figure C, the adapter must be grounded by attaching its grounding lug under the screw of the outlet cover plate. CAUTION: Before using an adapter, it must be determined that the outlet cover plate screw is properly grounded. If in doubt, consult a licensed electrician. Never use an adapter unless you are sure it is properly grounded.

Note: Use of an adapter is not permitted in Canada.

IMPORTANT: HOT BLENDING INSTRUCTIONS

To minimize possibility of scalding when blending hot ingredients, the following precautions and procedures must be observed:

1. Limit amount of material blended to one cup (8 oz.).

2. Completely remove the lid insert of the two-piece

container lid before starting motor. (This will allow venting of the rapidly heated and expanding air present inside container when blender is running.)

3. Start blending on low speed.

4. While blender is running, up to 1

⁄2 cups (12 oz.) of additional liquid can be added. Pour liquid slowly through the opening in the lid.

OPERATING INSTRUCTIONS

1. When placing the container on the unit base, make sure that the unit is turned OFF and is at a complete stop. Do not put the container on or take it off while the unit is running. Doing so may damage the drive shaft or blade assembly. For best results, do not fill container above 3-cup level.

2. Be sure the switch is in the OFF position and plug the blender into a convenient outlet.

3. The Waring A hint when mixing ice drinks: keep the blades in the container covered with liquid, turn the unit on, remove the lid insert on top of the jar lid, and feed the ice cubes slowly into the jar.

than Waring

4. Put ingredients into container, then put on cover. Always add liquid ingredients first, unless otherwise specified in recipe. Always hold container with one hand while blending.

CAUTION: To avoid damage to your blender, do not run

5. the blender if the blades become blocked or jammed during use. Turn the blender OFF immediately, remove the container from the blender base and dislodge the material that is blocking or jamming the blade.

Blendor is ideal for blending ice drinks.

NOTE: Never use containers other

Blendor containers with your unit.

NOTE: Your blender has a pulse feature located on the front of the base (black rubber circular piece). To use, press PULSE as needed.

7. For your safety and protection, this blender is equipped with a thermal protector. Should your blender overheat, the motor will automatically shut off. To restart, follow these steps:

• Unplug blender from electrical outlet.

• Let motor cool down for approximately 2 to 5 minutes depending on the contents in the blender.

• Once the motor has cooled down, plug unit into electrical outlet.

• Toggle to ON position and proceed.

+ 9 hidden pages