Conair NC03C Instruction & Styling Manual

IMPORTANT SAFETY
INSTRUCTIONS
THIS APPLIANCE IS INTENDED FOR HOUSEHOLD USE. WHEN USING ELECTRICAL APPLIANCES, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE TAKEN, INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS
KEEP AWAY FROM WATER
DANGER – To reduce the risk of elec-
trocution:
1. Always unplug this appliance immediately after using.
2. Do not use while bathing.
3. Do not place or store appliance where it can fall or be pulled into a tub or sink.
4. Do not place in or drop into water or other liquid.
5. Do not reach for an appliance that has fallen into water. Unplug immediately.
WARNING – To reduce the risk of burns,
electrocution, fire, or injury to persons:
1. Read all instructions before using the appliance.
2. To protect against electrical hazards, do not use while bathing or in the shower.
3. Close supervision is necessary when any appliance is used by or near children or by individuals with certain disabilities.
4. Unplug the appliance from outlet when not in use and before cleaning. Do not leave appliance unattended when it is plugged in. Keep cord away from heated surfaces.
5. Do not operate this appliance with a damaged cord or plug or if the appliance malfunctions or has been dropped or
damaged in any manner. Return appliance to nearest service facility for examination, electrical or mechanical adjustment, or repair. No repairs should be attempted by the consumer.
6. Use appliance only for intended use as described in this instruction book. The use of attachments not recommended or sold by Conair may cause hazards.
7. Do not use outdoors or operate where aerosol (spray) products are being used, or where oxygen is being administered.
8. Do not use on a soft surface such as a bed, where openings may be blocked.
9. Do not place or store appliance where it can fall or be pulled into a tub or sink.
10. Do not place in or drop into water or other liquid.
11. If an appliance falls into water, unplug it immediately. Do not reach into the water.
Use on any 120 volt 60 hertz AC electric
outlet (ordinary household current). Do not use it on any other electrical outlet.
12. Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
SAVE THESE
INSTRUCTIONS
PEDICURE
1. Soak your feet for five minutes in warm, soapy water and dry thoroughly.
2. Use the Smoothing Disc/Plate to reduce the length of the nail. Toenails should be filed straight across to avoid ingrown toenails. Use a fine Smoothing Disc/Plate on a low speed as a finishing touch to the edges.
3. To reduce calluses or rough or hard skin, use the Sapphire Cones or a Smoothing Disc/Plate. The thickness or dead skin can be reduced by using the side of the Sapphire Cones. Where ridges and furrows are present, the Smoothing Disc can also be used to gently and carefully reduce the uneven­ness, using short intermittent strokes. This is not recommended more than once every eight weeks.
4. Finish your pedicure by using a moisturizing lotion or cream.
MAINTENANCE
Your nail care centre is designed for household use and is virtually maintenance-free. No lubrication is needed. If cleaning becomes necessary, disconnect the appli­ance from the power source and wipe exterior with a cloth. If any abnormal condition occurs, unplug the nail care centre, allow it to cool, and return it to an authorized service centre for repair.
GETTING TO KNOW YOUR
COMPLETE NAIL CARE SYSTEM
1. Power Handle works corded or cordless
2. Variable Speed Control
3. On/Off Switch
4. Light
5. Nail Dryer
6. Manicurist’s Dish
7. Cuticle Shaper
8. Linear Head
9. Rotary Head
10. Metal smoothing plate
11. Smoothing Plate
12. Large Felt Cone
13. Shaping Disc
14. Medium Sapphire Cone *
15. Felt Buffing Disc
16. Soft Fabric Travel Pouch Included
* for acrylic nails
6
15
13
10
11
12
14
8
9
1
4
3
2
7
5
16
OPERATING
INSTRUCTIONS
1. Your Battery Operated Nail Care Center operates on 2 AAA batteries (not included) for the power handle and on 2 AA batteries (not includ­ed) for the nail dryer. Adapter can also be used to operate the power handle directly by plugging into the bottom of the handle.
2.
The power handle has two in­terchangeable heads. The rotary head works with round attachments that spin in a circular motion and the linear head works with rectangular plates that move in a back-and-forth motion. The rotary head is already attached to the power handle. Pull power handle up to remove from the attachment tray.
3. To change heads: twist the head in a counterclock­wise motion and pull up; head comes off. Gently push other head onto plastic base and twist slightly with clockwise motion until head clicks into secure position.
4. To attach discs, plates or cones to the ro­tary head, insert metal post of disc into the white plastic tube of head and gently push down. To attachplates to the linear head, match up rounded end of plate with round end of head and snap plate onto head. To remove attachments, simply pull off.
5. Your Nail Care Center contains a number of at­tachments. The coarser disc and plate are ideal for
shaping and eliminating ragged edges for a clean finish. The finer cones and plate smooth unsightly ridges. The polishing cone and disc provide the flawless, smooth surface needed for nail polish ap­plication and help polish nails to a healthy-looking luster.
6. To soften nails and cuticles before a manicure, pull out the manicur­ist’s dish, fill it with warm, soapy water and soak your finger tips for a few minutes. Dry your hands thoroughly before using the power handle and attachments.
7. After you have attached a head and an appropri­ate attachment to the power handle, turn the power handle “on” and carefully start shaping, smoothing or polishing your nails. You can vary the speed at which the attachment moves by turning the speed dial.
Slower speeds give you more control over the filing
procedure.
8. Your power handle also features a light to give you additional illumination when working on a nail.
9. Your Nail Care Center includes a nail dryer which will help shorten fresh nail polish drying time. Simply insert your hand into the nail dryer, pushing down slightly. That will start the nail dryer. Check nails after a few minutes to see if polish is dry.
10. After using the Nail Care Center several times, you will find the attachment and speed combinations that give you the results you desire.
Everyone knows that electricity and water are a dangerous combination. But did you know that an elec­tric appliance is still electrically live even if the switch is off? If the plug is in, the power is on. So when you are not using your appliances, keep them unplugged.
ALWAYS UNPLUG
SMALL APPLIANCES
A Public Service Ad from the Association of Home
Appliance Manufacturers and Underwriters Laboratories, Inc.
STORAGE
Disconnect from electrical outlet. Place nail care centre in cool, dry area out of reach of children, where it will not be damaged. Handle cord carefully for longer life; do not jerk or strain at plug connections, or wrap cord around unit for storage. This could cause dam­age to the cord or a short circuit. To store unit, coil cord loosely.
LIMITED ONE YEAR WARRANTY
Conair will repair or replace (at our option) your unit free of charge for 12 months from the date of purchase if the appliance is defective in workmanship or materials. To obtain service under this warranty, return the defective product to the service centre listed below that is nearest you, together with your purchase receipt and $5.50 for postage and handling. In the absence of a purchase receipt, the warranty period shall be 12 months from the date of manufacture.
ANY IMPLIED WARRANTIES, OBLIGA­TIONS, OR LIABILITIES, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTY OF MER­CHANTABILITY AND FITNESS FOR A PARTICU­LAR PURPOSE, SHALL BE LIMITED IN DURATION TO THE 12 MONTH DURATION OF THIS WRIT­TEN, LIMITED WARRANTY.
IN NO EVENT SHALL CONAIR BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR CON­SEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR IM­PLIED, WHATSOEVER.
This warranty gives you specific legal rights, and you may also have other rights, which vary from province to province.
WARNING:
IF YOU THINK
THE POWER IS OFF
WHEN THE SWITCH
IS OFF,
YOU’RE WRONG.
KEEP AWAY FROM WATER
SERVICE CENTRE:
Conair Consumer Products Inc. 100 Conair Parkway, Woodbridge, Ontario. L4H 0L2 1-800-472-7606 Consumer Call Centre E-mail: Consumer_Canada@Conair.com www.conaircanada.ca
©2009 CONAIR CONSUMER PRODUCTS INC.
09CN14014
IB-9291
MANICURE
1. Soak your nails in warm soapy water, then dry thoroughly.
2. Decide on the nail shape you want. The three most common nail shapes are round, square, or square with rounded edges.
3. Use the Smoothing Disc/Plate to smooth the edges of each nail. Then use the rounded end of the Cuticle Shaper to gently push the cuticles away from the nail plate. If desired, massage lotion or cream into the cuticle to help soften cuticle and promote healthy nails. Unwanted rough or hard skin can be reduced by using the Smoothing Disc. In cases where ridges and furrows are present, the Smoothing Disc/Plate can be used to gently and carefully reduce the unevenness, using short intermittent strokes. This is not recommended more than once every eight weeks.
4. To give nails a healthy, natural look, use the Polishing Disc or Cone, maximum of 30 seconds per nail, taking care to avoid the cuticle.
5. Finish your manicure by using a moisturizing lotion or cream.
IB-9291
INSTRUCTION & STYLING GUIDE
For your safety & continued enjoyment of
this product, always read the instruction
book carefully before using.
MODEL NC03C
The CompleTe
Nail CaRE
CenTre
HAVE A QUESTION?
Please do not return this product to the retailer.
CALL US FIRST!
Our customers service and product experts are
ready to answer ALL your questions. Please call
our TOLL-FREE customer service number at :
1-800-472-7606
Or visit us online at
www.conaircanada.ca
Loading...