Conair LT10WCSC Instruction Manual

IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, especially when children are present, basic safety precautions should always be followed, including the following:
READ ALL INSTRUCTIONS
BEFORE USING
KEEP AWAY FROM WATER
DANGER –
To reduce the risk of injury:
1. Do not place or store appliance where it can fall or be pulled into a tub or sink.
2. Do not use appliance while bathing or in the shower.
3. Do not place appliance in, or drop into water or other liquid.
WARNING–
To reduce the risk of burns, fire, or injury to persons:
1. This appliance should not be used by, on, or near children or individuals with certain disabilities.
2. Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer.
3. Never operate the appliance if it is not working properly, has been dropped or damaged,or dropped into water. Return the appliance to a Conair service centre for examination and repair.
4. Never drop or insert any object into any opening of the appliance.
5. Do not place the appliance on any surface while it is operating.
6. Do not use the appliance with a damaged or broken comb or with teeth missing from the blades, as injury may result. Before each use, make certain the blades are aligned properly.
7. Do not use the appliance outdoors or operate where aerosol (spray) prod­ucts are being used or oxygen is being administered.
SAVE THESE
INSTRUCTIONS
TROUBLESHOOTING
There are several things to look for if your trimmer fails to operate:
1. Be sure the trimmer is turned ON.
2. Make sure that the battery is properly placed in the battery compart­ment. Test the battery to be sure it is working.
3. Check the blades to see if they are clogged with hair clippings; if so, use the cleaning brush to remove hair.
4. If the trimmer still fails to operate, take or send it to a Conair Service Centre (see warranty procedure and addresses).
TOUT D’ABORD
CHANGER LA TÊTE DE COUPE
Commencez à la position verrouillée (ill. 1).
TAILLER LES SOURCILS
Attachez la tête an-
gulée de tondeuse
3/8 po sur la-quelle
TO TRIM YOUR EYEBROW
Attach the 3/8” trimmer head and then the eyebrow comb attachment to 3/8” angled head. This comb has two positions. At first, use the longest trim setting (you can always go back and make your eyebrows a little shorter). Slide the eyebrow comb attachment over the trimmer head until it sits securely in posi­tion. Starting from the centre of your brow, use smooth even strokes. Never attempt to trim against the natu­ral growth of your eyebrow, because the hair will be cut too short. With the comb removed, you can shape and define your eyebrow. Move the unit slowly so as not to cut any hairs you do not intend to trim.
FOR HOUSEHOLD
USE ONLY
OPERATING INSTRUCTIONS
FOR YOUR LT10WCSC
1. Remove the battery cover by rotating the bottom cap counter clock­wise and lifting straight off.
2. Being careful not to bend the clips, insert the positive end of the battery first, so it will slip easily into position.
3. Return the battery cover to its original position by pushing it in and rotating clockwise until you hear a small click as it locks into place.
4. To use your trimmer, push ON/OFF switch upwards to ON position.
5. After you finish using your trimmer, push down on the ON/OFF switch to turn the trimmer off.
*The LT10WCSC requires 1 “AA” battery (not included). We recommend using
alkaline batteries in your trimmer because they last longer. If you are not going to use your trimmer for a long period of time, or if the battery is dead, remove the battery from the unit. This will increase the life of your trimmer.
GETTING STARTED
TO SWITCH TRIMMER HEADS
Begin with trimmer in locked position (Fig.
1). Hold the handle of the trimmer while turning the trimmer head counterclockwise until the triangle on the trimmer head is aligned with the dash on the side of the
handle (Fig. 2). At this point you should be able to easily lift the trimmer head from the handle (Fig. 3). To replace a trimmer head, align the triangle on the trimmer head with the dash on the side of the handle and turn clockwise until the two triangles are aligned.
OUTLINING
1. The (3/4”) bikini trimmer is espe­cially useful for providing shape and definition. It is best to begin with clean slightly damp hair.
2. Beginning at the sides, use the cutting blades to define the shape.
3. If you would like to shorten your hair, run the blades over your hair until the desired length is achieved using even strokes.
4. Two separate attachment combs provide 5 different cutting positions for fine detailing.
pé, endommagé ou s’il est tombé
dans l’eau. Présentez-le à un service
après-vente il sera inspecté et
RÉSERVÉ À
L’USAGE MÉNAGER
Ill 1. Ill 2. Ill 3.
Loading...