IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, especially
when children are present, basic safety precautions should always be followed, including
the following:
READ ALL INSTRUCTIONS
BEFORE USING.
KEEP AWAY FROM WATER
DANGER -
Any appliance is electrically
live even when the switch is off. To reduce
the risk of death by electric shock:
1. Always unplug appliance immediately
after using.
2. Do not use while bathing.
3. Do not place or store appliance where it
can fall or be pulled into a tub or sink.
4. Do not place in, or drop into, water or other
liquid.
5. If an appliance falls into water, unplug it
immediately. Do not reach into the water.
WARNING - To reduce the risk of burns,
electrocution, fire, or injury to persons:
1. This appliance should never be left unat-
tended when plugged in.
2. Do not pull, twist, or wrap line cord
around appliance.
3. This appliance should not be used by, on
or near children or individuals with certain
disabilities.
4. Use this appliance only for its intended
use, as described in this manual. Do not
use attachments not recommended by the
manufacturer.
5. Never operate this appliance if it has a
damaged cord or plug, if it is not working
properly or if it has been dropped or damaged, or dropped into water. Return the
appliance to an authorized service center
for examination and repair.
6. Keep the cord away from heated surfaces.
7. Never use while sleeping.
8. Never drop or insert any object into any
opening.
9. Do not use outdoors or operate where
aerosol (spray) products are being used or
where oxygen is being administered.
10. Unit is hot when in use. Do not let heated
surfaces touch eyes or bare skin.
11. Do not place the heated unit directly on
any surface while it is hot or plugged in.
12. Never block the air openings of the appli-
ance or place on a soft surface such as
a bed or couch, where the air openings
may be blocked. Keep the air opening
free of lint and other debris.
13. Do not use an extension cord with this
appliance.
14. Do not touch hot surfaces of the
appliance. Use handles or knobs.
15. Before plugging in, read the informa-
tion about dual voltage contained in the
instruction section of this booklet.
16. Do not attempt to touch the housing of
your appliance near the straightening
plates, as it is hot when in use.
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
This straightening iron is intended for household use. Use on Alternating Current (50/60
hertz) only. This unit is designed to be operated at 120/240 volts A/C. The appliace has
a polarized plug (one blade is wider than the
other). As a safety feature, this plug will fit in
a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified
electrician. Do not attempt to defeat this
safety feature.
DUAL VOLTAGE
This straightening iron will automatically
adjust to the proper voltage. Use an adapter
plug with correct configuration, prior to use
in outlet.
TO STRAIGHTEN HAIR
Plug the straightening iron cord into any
household outlet (120/240V). The red LED
will come on indicating the unit is plugged in.
Press the On button (the red and green LEDs
will blink indicating that the straightener is
heating up). The red light will shut off once
the iron has reached the optimal heat level.
The iron will heat up very quickly. Hair should
be clean and completely dried before using
the straightening iron. For best results, use
a light styling product before blow-drying
hair. To turn off, press Off button (red light will
go off). Never leave your straightening iron on
and unattended. However, should you fail to
turn the unit off, it will shut itself off automatically within 60 minutes.
WARNING: The straightening iron's ceramiccoated plates will get very hot within a few
seconds and should not be placed in contact
with the skin after the straightening iron has
been turned on.
GETTING STARTED
The iron’s 20 temperature settings and
Instant Heat technology provide styling
versatility for all hair types. If you have fine
hair, a low temperature will provide the best
results. If you have thick, wavy or hard-tostraighten hair, keep the heat setting on
high. You can vary the iron’s temperature
straighten and style your hair easily.
STYLING WITH THE NEW EASY-GLIDE
CERAMIC-COATED PLATES
The plates of your new straightening iron
have a Satin Finish
®
Easy-Glide ceramiccoated surface, the newest technology. The
ceramic-coated surface also helps smooth
down flyaways and frizzies. It evenly distributes heat so that the style you create has a
salon-perfect, silky smooth, shining finish.
Hair also slips right through the plates after
it’s straightened. This means it’s not only
simpler to clean off styling product residue,
etc., after each use, but you’ll find that hair
glides easily over the surface of the plates
as you’re straightening.
The new ceramic technology is a pleasure to
work with and makes styling your hair easier
and the results more professional.
USING INSTANT HEAT, THE 20 VARIABLE
TEMPERATURE SETTINGS AND
UNIFORM HEAT RECOVERY SYSTEM
This styling iron features Conair’s Instant Heat
technology. This Instant Heat technology has
20 variable temperature settings. Every type
of hair, from the finest to the curliest and most
resistant, has a temperature range that’s
gentle and safe for it and helps you create
the look you want. And that’s not all. Conair’s
professional salon standards of engineering
provide you with a Uniform Heat Recovery
System that maintains the iron at constant
temperatures. There is a constant flow of
power to ensure that heat is continuously
delivered for optimal styling results, unlike
other units that lose heat during use. This
provides consistent styling power so that
every strand of your hair is set with the same
level of heat and comes out the same way for
a perfect finish.
Temperature Setting Guide
TEMP. CONTROL HAIR TYPE
Low 1-5 Delicate, thin, easy-to-straighten
Medium 6-10 Average to thick or treated hair
Med-High 11-15 Thick or wavy hair
High 16-20 Hard-to-straighten hair
according to your particular need!
Start with a hair section that is 2" wide
and no more than 1/2" thick. Open the
iron and place a hair section between the
two hot plates, close to the scalp. Trap hair
between the plates by firmly squeezing the
handles together. While maintaining the tension, slowly pull the unit down along the hair
section toward the end of hair. At the end
of hair section, release the pressure on the
handle and allow the hair section to slide
out. Repeat process on additional sections
of hair until you achieve the hair style you
desire. It may be necessary to repeat process
on certain areas, depending on the texture of
your hair.
Some experience is necessary when learning
to use this straightening iron. After using iron
several times, you will learn the ideal way to