Conair CS2025NJCCSC Instruction Manual

Page 1
Page 2
IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, especially when children are present, basic safety precau­tions should always be followed, including the following:
READ ALL INSTRUCTIONS
BEFORE USING
KEEP AWAY FROM WATER
DANGER -
Any appliance is electri­cally live even when the switch is off. To reduce the risk of death by electric shock:
1. Always unplug appliance immediately
after using.
2. Do not use while bathing or in a shower.
3. Do not place or store appliance where it
can fall or be pulled into a tub or sink.
4. Do not place in, or drop into water or other
liquid.
5. If an appliance falls into water, unplug it
immediately. Do not reach into the wa-
ter.
WARNING -
To reduce the risk of burns,
electrocution, fire, or injury to persons:
1. This appliance should never be left unat-
tended when plugged in.
2. This appliance should not be used by,
on, or near children or individuals with cer­tain disabilities.
3. Use this appliance only for its intended use
as described in this manual. Do not use attachments not recommended by the manufacturer.
4. Do not use an extension cord to operate appliance.
5. Never operate this appliance if it has a damaged cord or plug, if it is not work­ing properly, if it has been dropped or damaged, or dropped into water. Return the appliance to an authorized service centre for examination and repair.
6. Keep the cord away from heated surfac­es.
7. Do not pull, twist, or wrap line cord around appliance, even during storage.
8. Never block the air openings of the appliance or place it on a soft surface such as a bed or a couch, where the air openings may be blocked. Keep the air openings free of lint, hair and other debris.
9. Never use while sleeping.
10. Never drop or insert any object into any opening.
11. Do not use outdoors or operate where aero­sol (spray) products are being used or where oxygen is being administered.
12. This straightener is hot when in use. Do not let eyes or bare skin touch heated surfaces.
13. Do not place the heated straightener directly on any surface or on the appli­ance power cord while it is hot or plugged in.
14. Do not touch hot surfaces of the appliance; use handles or knobs.
15. Do not attempt to touch the housing of your appliance near the straightening plates as it is hot when in use.
SE COIFFER AVEC LES NOUVELLES
PLAQUES ENDUITES DE CÉRAMIQUE
EASY-GLIDE
Page 3
Page 4
16. Before plugging in read the information about dual voltage contained in the instruction section of this manual.
17. Do not use with a voltage converter.
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
This straightening iron is intended for household use. This unit is designed to operate at 120 ­240V volts AC. Use on Alternating Current (50/60 hertz) only.
This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.
DUAL VOLTAGE
This straightening iron will automatically adjust to the proper voltage. Use an adaptor plug with correct configuration prior to use in outlet.
STRAIGHTENING BASICS
Plug the straightening iron cord into any house­hold outlet (120-240V). Slide ON/OFF cap to ON position. Light will remain on. The iron will heat up very quickly. To turn off, slide ON/OFF button to OFF position. Light will go off. Never leave your straightening iron on and unattended.
WARNING: The straightening iron’s ceram­ic-coated plates will get very hot within a few seconds and should not be placed in contact with the skin after the straighten­ing iron has been turned on.
Start with a hair section that is 2" wide and no more than ½" thick. Open the iron and place a hair section between the two hot plates, close to the scalp. Close plates over hair by firmly squeezing the handles together. While maintain­ing the tension, slowly pull the unit down along the hair section toward the end of hair. At the end of hair section, release the pressure on the handle and allow the hair to slide out. Re­peat process on additional sections of hair until you achieve the hair style you desire. It may be necessary to repeat process on certain areas, depending on the texture of your hair.
Some experience is necessary when learning to use this straightening iron. After using the iron several times, you will learn the ideal way to straighten and style your hair easily.
16. Avant de brancher l’appareil, lisez les
directives concernant l’utilisation bitension,
dans le manuel.
ÉLÉMENTS DU DÉFRISAGE
Branchez le fer à défriser dans une prise de
courant ordinaire (120 à 240 V). Glisse sur ON/
Page 5
Page 6
STYLING WITH THE NEW EASY-GLIDE
CERAMIC-COATED PLATES
The plates of your new straightening iron have an easy-glide ceramic surface, the latest in technological advances. The ceramic even heat distribution produces the ultimate in healthy, shiny, silky hair. You’ll find that hair glides easily over the surface of the plates as you’re straightening, and that it is easier to clean styling products residue, etc. off the plates after each use. The ceramic surface also helps smooth down flyways and frizzies. As you smooth your hair, heat is evenly distributed so that the style you create has a salon-perfect, silky smooth, shiny finish. Hair also slips right through the plates after it’s straightened.
The new ceramic technology is a pleasure to work with, makes styling your hair easier and provides professional results.
CONSIGNES
IMPORTANTES
5. N'utilisez jamais l'appareil si le fil ou la
fiche est endommagée, s'il ne fonctionne
pas bien, s'il a été échappé ou
endommagé, ou s'il est tombé dans l'eau.
Loading...