Conair BE6BXBR Installation Instructions Manual

IMPORTANT SAFETY
INSTRUCTIONS
WHEN USING AN ELECTRICAL FURNISHING, BASIC PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS
BEFORE USING THIS
FURNISHING
OF ELECTRIC SHOCK: ALWAYS UNPLUG THIS FURNISHING FROM THE ELECTRICAL OUTLET BEFORE CLEANING.
WARNING TO REDUCE THE RISK
OF BURNS, FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS:
1. Unplug from outlet before putting on or taking
off parts.
2. Close supervision is necessary when this furnishing is used by or near children, invalids, or disabled persons.
3. Use this furnishing only for its intended use as described in these instructions. Do not use attachments not recommended by the manufacturer.
4. Never operate this furnishing if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the furnishing to a service center for examination and repair.
5. Keep the cord away from heated surfaces.
6. Never drop or insert any object into any opening.
7. Do not use outdoors.
8. Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
9. Never operate the furnishing with the air openings blocked, keep the air openings free of lint, hair, and the like.
10. To disconnect, turn all controls to the OFF or O position, then remove plug from outlet.
11. Be sure mirror is not in a position where it can
reflect sunlight; reflected sunlight can cause fire.
12. Do not use on a soft surface such as a bed, where openings may be blocked.
13. Turn switch to OFF or O position, allow unit to
cool and unplug cord before replacing light bulbs.
14. Do not place or store this furnishing where it can
fall or be pulled into a tub or sink.
15. If this furnishing falls into water, unplug it
immediately. Do not reach into the water.
16. Never use while sleeping.
17. Do not use bulb greater than 25 watts.
Use in any 120 volt, 60 hertz AC electric outlet (ordinary house current). Do not use it in any other electrical outlet.
18. To protect against electrical hazards, do not use
while bathing or in the shower.
19. Unplug the furnishing from outlet before
cleaning. Do not leave mirror unattended when it is plugged in.
FOR HOUSEHOLD USE ONLY
SAVE THESE
INSTRUCTIONS
INSTALLATION INSTRUCTIONS
Wall Mount Mirror
1. Remove mounting bracket from base of mirror. Leave
long screws in bracket.
2. Using 3/8-inch drill size, drill two holes in wall the same distance apart as two opposite slots in bracket. Screw into wall stud if possible. If drilling into stud, use 1/8-inch drill size. Otherwise, insert two wall anchors in holes.
CAUTION: Do not drill into electrical wiring through wall. Check with electrician if necessary.
3. Screw bracket onto wall, into the anchors.
4. Attach mirror to bracket by placing long screws through the two holes in mirror’s base. Secure with knurled nuts. Cord should be extending toward floor.
OPERATING
INSTRUCTIONS
To reduce the risk of electric shock, this mirror has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Never use with an extension cord unless plug can be fully inserted. Do not change the plug in any way.
1. Your lighted makeup mirror will adjust to many different angles. Simply tilt the head backward or forward to adjust to the desired angle. Your mirror will also swivel so that you can use either the normal view or the magnifying view located on the opposite side.
2. Plug into any standard wall outlet (120 volt AC). Turn the rotary switch clockwise to the ON or 1 position.
3. After use, turn switch clockwise again to the OFF or O position.
TO REPLACE BULB
CAUTION: TURN OFF POWER AND UNPLUG. ALLOW TO COOL AT LEAST 3 MINUTES BEFORE REPLACING BULB.
Figure 2
Figure 1
NOTE: Do not use a bulb greater than 25 watts. Contact the Conair Service Center at 1-800-3 CONAIR for replacement bulb information; ask for replacement bulbs #RP65B. Bulbs are $5.99 each.
1. Unscrew and remove knurled thumb screws from opposite sides of the mirror housing near the rotating hinges (Fig. 1).
2. Carefully lift off the top half of the housing from the bottom half that is affixed to the stand.
3. Unscrew the old bulb and replace with the new bulb (Fig. 2).
4. Carefully replace the top housing half after locating and aligning the screw holes to the bottom half. If the holes don’t line up, turn top half of mirror 180˚.
5. Insert two knurled thumb screws into screw holes and hand-tighten.
Model BE6BXBR
For your safety and continued enjoyment of this product,
always read the instruction book carefully before using.
LIMITED ONE-YEAR WARRANTY
Conair will repair or replace (at our option) your unit free of charge for 12 months from the date of purchase if the appliance is defective in workmanship or materials.
To obtain service under this warranty, return the defective product to the service center listed below, together with your purchase receipt and $3.00 for postage and handling. California residents need only provide proof of purchase and should call 1-800-366-0937 for shipping instructions. In the absence of a purchase receipt, the warranty period shall be 12 months from the date of manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS, OR LIABILITIES, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL BE LIMITED IN DURATION TO THE 12-MONTH DURATION OF THIS WRITTEN, LIMITED WARRANTY. Some states do not allow limitations on
how long an implied warranty lasts, so the above limita­tions may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR IMPLIED, WHATSOEVER. Some
states do not allow the exclusion or limitation of special, incidental, or consequential damages, so the above limi­tation may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state.
Please register this product at: www.conair.com/registration
Service Center
Conair Corporation Service Department 7475 North Glen Harbor Blvd. Glendale, AZ 85307
©2013 Conair Corporation Model BE6BXBR 13PM144221
IB-12380
MAINTENANCE
Your lighted mirror is designed for household use and is virtually maintenance free. No lubrication is needed.
If cleaning becomes necessary, disconnect the appliance from the power source, allow to cool and wipe exterior with a cloth. Clean mirror surfaces with a glass cleaner. Do not light until you are certain mirror is completely dry, to protect against electrical hazards.
If any abnormal condition occurs, unplug the lighted mirror, allow it to cool, and return it to an authorized service center for repair.
Handle cord carefully to prolong its life; do not jerk or strain at plug connections, or wrap cord around mirror for storage. This could cause damage to the
KEEP AWAY FROM WATER
Everybody knows that electricity and water are a dan­gerous combination. But did you know that an electri­cal appliance is still electrically live even if the switch is off? If the plug is in, the power is on. So when you are not using your appliances, keep them unplugged.
ALWAYS UNPLUG
SMALL APPLIANCES
CAUTION: TO PREVENT ELECTRIC SHOCK,
MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
CAUTION: RISK OF
FIRE, USE ONLY 25 WATTS MAXIMUM 120 VOLT, TYPE T BULBS.
DISCONNECT FROM THE SUPPLY CIRCUIT BEFORE SERVICING OR CLEANING.
DO NOT SUBMERSE.
MODEL: BE6BXBR
RATING: 120V AC 60Hz 25W
DATE CODE:
cord and the mirror could short circuit. To store mirror, coil cord loosely.
STORAGE
Disconnect from electrical outlet. BE SURE DIRECT SUNLIGHT DOES NOT STRIKE MIRROR WHEN LEFT UNATTENDED; REFLECTED SUNLIGHT CAN CAUSE FIRE. Allow to cool to room temperature before stor­ing. Place in cool, dry area out of reach of children, where mirror will not be damaged.
WARNING:
IF YOU THINK THE
POWER IS OFF WHEN
THE SWITCH IS OFF,
YOU’RE WRONG.
incandescent
lighting
Loading...