Page%1%
Quick Installation Guide
GS-7324| 24-Port Gigabit Ethernet Switch + 2 SFP
Understanding your Switch
This switch contains LEDs to show the activities and status of the ports, including the POWER LED and LINK/ACT LEDs.
Please refer to the front panel of the switch for the positions of the LEDs :
Look at the following table for the description of the LEDs:
LED
Status
Operation
POWER
Steady Green
The switch is powered on
Off
The switch is powered off
LINK/ACT
1-24
Steady Green
1000Mbps connected
Blinking
Data transmitting
Off
Port disconnected or link fail
SFP
Steady Green
Port Connected
Blinking
Data transmitting
Off
Port disconnected or link fail
Rear Panel
A
Page%2%
Basic Setup
1. Power On the Switch by plugging it into the power outlet. The POWER LED turns on when the switch is receiving
power.
2. Using an Ethernet cable, connect your Network device (Modem, Router or Access Point) to any port on the
switch.
3. Connect the Switch to other Internet-Enabled Devices.
You Have Successfully Installed Your Gigabit Ethernet Switch
Troubleshooting
The following information should help you diagnose basic setup or installation problems.
1) POWER Indicator is OFF: If the POWER LED goes off, please make sure that your power outlet is working properly
(perhaps by testing with another device). Then plug in your GS-7324 again. If the Power Indicator does not light up,
please contact your equipment supplier for further information.
2) NETWORK LED is OFF: If a LAN LED fails to light up, check that the LAN port of the Switch is connected firmly to
the LAN port of the other device. To check the condition of the Ethernet cable, use another cable to test the
same connection.
FOR MORE HELP: For instructions on advanced features, FAQ, etc., please visit our product online at:
http://us.comtrend.com
For more information:
YouTube Channel: https://www.youtub.com/user/ComtrendConnection
Facebook: https://facebook.com/Comtrend
Website: http://us.comtrend.com/
Support: Visit our website or call 1-877-COMTREND (1-877-266-8736)
C
Step 3
Step 2
Step 1
B
D
Network Device
(Modem, Router, or
Access Point)
AC Power
Internet- Enabled
Devices
Laptop
PC
Loading...