Page 1
COMTECH TECHNOLOGY CO., LTD.
FM1394TSIM
1. SCOPE
This specification outlines the pertinent electrical requirements of the RF output
modulator which converts the FM video and FM audio signal into the RF signal for
television standard transmission system.
2.GENERAL SPECIFICATIONS
2-1. Output frequency 1340 ~1450mhz (I
2-2. Supply voltage 12v+/-0.2V
2-3. Consumption current 140+/-20 mA
2-4. Operation and storage temperature 0-50oC
Conditions for guarantee humidity 85% or less
2
C PLL controller from outside)
3.Test Conditions
3-1. Testing ambient conditions
Defined as temperature of 25+/-2oC and humidity of 65+/-5% RH.
Note that temperatures of 5-30oC and humidity of 45-85% RH may be regarded
as standard.
3-2. Unit setting conditions
(1). Picture --10 step wave signal 1.0Vp-p(82 Ohm load)
(2). Audio -- 1.0Vp-p of sine wave 1KHz
Aug,15, 2001 1
Page 2
COMTECH TECHNOLOGY CO., LTD.
FM1394TSIM
4. Electrical Performance
4-1. Video system characteristics
Specification
parameter min typ max unit Remark
4-1-1 Input impedance 1.7k ohm Measure at 0.5-mhz
4-1-2 Input signal level 1.0 Vp-p Load of 82ohm connected
negative synchronous
4-1-3 Modulation 1340~1450 6 8 10 MHz Superimposed sinuous wave.
sine wave 10khz 1Vp-p (3.58mhz)is 20% of the step input
4-1-4 Differential gain -8 8 % level measure under the apl of
10-90% differential gain of
demodulator unit is to be
compensated
4-1-5 Differential phase -8 8 deg -ditto 4-1-6 S/N 45 dB Measuer mith respeot to standard
demodulator output.
4-1-7 Out level taper 4 6 dB fp 1340~1450mhz
4-2. Audio system characteristics
4-2-1 Input impedance 1.4 Kohm Measure at 0.1-10 KHz
4-2-2 Modulation 35 40 45 KHz
4-2-3 Distortion factor 3 % Audio input signal 1.0Vp-p 1khz
modulation 50% (sine wave) video
input signal all black (sync.only)
use standard demodulator of inter
-carrier system.
De-emphasis(50 usec) is on.
4-2-4 S/n 40 dB The same as 4-2-3
Aug,15, 2001 2
Page 3
COMTECH TECHNOLOGY CO., LTD.
4-3. Output system characteristics
Specification.
Parameter Min Typ Max Unit Remark
4-3-1 Video carrier frequency -50 fp +50 KH z Test at 25OC temperature and
4-3-2 Video output level 14 16 17 65% RH of humidity
1340~1450 MHz Fs1 6.0 MHz
Fs2 6.5 mhz *output channel
4-3-3 Audio output level 22 27 32 dB
difference(p/s ratio)
fp:1340~1450mhz
4-3-4 Audio carrice frequency -8 fs1+8 KHz Input signal none the measurement
is taken after 30 sec. from the
power-on.
4-3-5 Audio modulator fs1 30 40 50 KH z Measurement difference video of
FM1394TSIM
fs2 30 40 50 carrier frequency output level for
1340~1450MHz. Except to fp.
fp+/-fs against video carrier
4-3-6 Out-band spurious 45 50 dB output level.
4-3-7 Output impedance 75 Oh m Unbalanced
Aug,15, 2001 3
Page 4
COMTECH TECHNOLOGY CO., LTD.
5-1. PLL section characteristics
No Item Specification notes
5-2. IIC Bus
(1) SDA, SCL Under standard test condition
input voltage Condition Min T y p Max
High voltage 3 5
Low voltage 0 1.5 V
(2) Address C2 (on write date format)
(3) SDA SCL SDA/SCL are in the high impedance
input impedance and there should be no reliablity
problem with 5V continually on the
SDA/SCL, if power supply is switched off.
(4) Data format Msb Lsb
FM1394TSIM
Address 1 1000Ma1Ma00AByte1
Programmable 14 13 12 11 10 9 8
Divider 0 2222222AByte2
Programmable 7 6 5 4 3 2 1 0
Divider 2 2222222AByte3
Charge pump (0) (0)
and test bits 1 cp t1 t0 1 1 1 os A Byte4
I/o port control bits p7 p6 p5 p4 p3 p2 p1 p0 A Byte5
Table 1 write data format (msb is transmitted first)
Address 1 1000MA1MA21AByte1
Status byte POR FL I 2 I 1 I 0 A2 A1 A0 A Byte2
Table 2 read date format
A.acknowledge bit.
MA1,MA0.voltage address bits.
Cp,charge pump current select.
T1:test mode selection,T0:charge pump disable
Os,varactor drive output disable switch.
P7,P6,P5,P4,P3,P2,P1,P0;controloutput states.for power on reset indicator
FL:phase lock detect flag
I2,I1,I0:digital information from ports P7,P5,and P4.
A2,A1,A0:5 level adc data from P6
Aug,15, 2001 4
Page 5
COMTECH TECHNOLOGY CO., LTD.
FM1394TSIM
Aug,15, 2001 5
Loading...