Comstar B2201334 User Manual

CI-POE-A/C-32
Synthetic Polyol Ester Refrigeration Lubricant
Safety Data Sheet (SDS)
OSHA HazCom Standard 29 CFR 1910.1200(g), Rev. 2012 and GHS Rev 03.
1. Identification
Product identifier
Trade name Product description
Manufacturer/supplier
CI-POE-A/C-32 Synthetic Polyol Ester Refrigeration Lubricant
Comstar International 20-45 128th Street - College Point, NY 11356 (800) 328-0142
Emergency telephone number
(800) 328-0142
2. Hazard(s) Identification
Classification of the substance or mixture The substance is not classified according to the Globally Harmonized System (GHS).
Label elements
GHS label elements Non-regulated material Hazard pictograms Non-regulated material Signal word Non-regulated material Hazard statements Non-regulated material
Classification System
NFPA ratings (scale 0-4)
HMIS-ratings (scale 0 - 4) Health=0; Fire=1; Reactivity=0
Health=0; Fire=1; Reactivity=0
Page 1 of 8 Revision Date:
2015-05-27
CI-POE-A/C-32 - Synthetic Polyol Ester Refrigeration Lubricant
3. Composition / Information on Ingredients
Chemical characterization Mixtures Description Mixture of the substances listed below with nonhazardous additions Dangerous Components Non-regulated material
4. First-aid Measures
Description of first aid measures
General information No special measures required After inhalation Supply fresh air; consult doctor in case of complaints After skin contact Generally the product does not irritate the skin After eye contact Rinse opened eye for several minutes under running water After swallowing If symptoms persist, consult doctor Most important symptoms and effects,
both acute and delayed Indication of any immediate medical
attention and special treatment needed
No further relevant information available
No further relevant information available
5. Fire-fighting Measures
Extinguishing media
Suitable extinguishing agents Use fire fighting measures that suit the environment Special hazards arising from the
substance or mixture
Advice for firefighters
Protective equipment
No further relevant information available
As in any fire, wear self-contained breathing apparatus pressure-demand (NIOSH approved or equivalent), and full protective gear to prevent contact with skin and eyes.
6. Accidental Release Measures
Personal precautions, protective equipment and emergency procedures
Environmental precautions No special measures required Methods and material for
containment and cleaning up
Reference to other sections
Not required
Absorb with liquid-binding material (i.e. sand, diatomite, acid binders, universal binders, sawdust).Dispose of the collected material according to regulations.
See Section 7 for information on safe handling. See Section 8 for information on personal protection equipment. See Section 13 for disposal information.
Page 2 of 8 Revision Date:
2015-05-27
CI-POE-A/C-32 - Synthetic Polyol Ester Refrigeration Lubricant
7. Handling and Storage
Precautions for safe handling No special measures required Information about protection against
explosions and fires
Conditions for safe storage, including any incompatibilities Storage
Requirements to be met by storerooms and receptacles
Information about storage in one common storage facility
Further information about storage conditions
Specific end use(s) No further relevant information available
8. Exposure Controls / Personal Protection
Additional information about design of technical systems
Control parameters
Components with occupational exposure limits
Additional information The lists that were valid during the creation were used as basis
Exposure controls Personal protective equipment
General protective and hygienic measures
Breathing equipment
Protection of hands
Material of gloves Not required Penetration time of glove material Not applicable
Eye protection
No special measures required
No special requirements
Not required
None
No further data; see section 7
The product does not contain any relevant quantities of materials with critical values that have to be monitored at the workplace
The usual precautionary measures for handling chemicals should be followed
Normally not necessary. If mist is generated, wear approved organic vapor respirator suitable for oil mist areas with sufficient oxygen.
Normally none required, for direct contact of more than 2 hours, PVC, Viton, or Nitrile gloves are recommended.
Normally none required, chemical goggles if splashing is likely or high pressure systems are used.
Page 3 of 8 Revision Date:
2015-05-27
Loading...
+ 5 hidden pages