CompX Latch Upgrade User Manual

Refrigerator Kit

Below are instructions for upgrading a refrigerator kit to the new latch. Contact CompX Security Products at 864.297.6655
with any questions or for additional help.

Included in this kit are
(shown left to right, top to bottom):

k Refrigerator lock housing

k Motorized latch

k Refrigerator housing back cover

k Three (3) pieces of mounting tape

k Strike

k Two (2) bezel mounting screws

k Four (4) latch mounting screws

CompX eLock • compx.com

k Four (4) washers

k Two (2) strike cover machine screws

k Four (4) housing cover screws

k Eight (8) sheet metal mounting screws

Tools needed:

k #2 Philips driver

k T15 pin-in-head Torx driver

1

Refrigerator Kit

Step 1

Remove the existing refrigerator lock and strike from the refrigerator
that it is installed upon.

Step 2

Remove four back cover screws with #2 Phillips screwdriver. Remove
cover and discard.

Step 3 – Removing the latch

Disconnect the latch cable and remove the latch by removing four (4)
latch screws with a #2 Phillips screwdriver. Discard latch and screws.

3A – Disconnect latch cable.

3B – Remove latch screws (4).

CompX eLock • compx.com

3C – Discard latch and latch screws.

2

Refrigerator Kit

Step 4 – Removing the batteRy box (DO NOT DAMAGE)

Disconnect battery cable and RJ11 cable from main access control
unit. MAKE SURE to depress connector locks before removing cables,
or permanent damage will result.

4A – Illustration of connector locks.

4C – Using large slotted screwdriver, deflect housing wall to allow to

battery box to be removed.

4B – Depress connector locks and remove battery cable and RJ11 cable.

CompX eLock • compx.com

Step 5 – Removing the bezel (DO NOT DAMAGE)

Remove main access assembly by removing two (2) screws with #2
Phillips screwdriver.

3