Com-Power PAM-118 User Manual

Features
Ultra Wideband - 500 MHz - 18 GHz
High Gain - 24 dB minimum
Flat Response - ± 1.25 dB.
Low Noise Figure - 3 dB max.
Power @1 dB Gain Compression - +17 dBm
Preamplier
PAM-118
Description
The model PAM-118 is a broadband, high gain, bench top microwave preamplier. The PA-118 has a frequen­cy range of 500 MHz to 18 GHz. This preamplier is primarily intended for EMC applications. However, it can be used for other application that require signal amplication. The PAM-118 reduces oor noise and increases system sensitivity to low level signals during Electromagnetic Interference (EMC) testing.
The simple front panel consists of two 50 Ohm matched SMA connectors for input and output. The preamplier was designed to have minimal gain variation for the entire frequency range. The consistent gain reduces EMC measurement errors. It also has low VSWR and noise gure.
Each preamplier is individually calibrated using equipment traceable to National Institute of Standards and Technology. The data and certicate of calibration is shipped with the unit. The PAM-118 is powered by 18 VDC, 1 Amp wall plug adapter.
Application
The PAM-118 preamplier increases system sensitivity to low level signals from equipment under test during EMC testing. It also provides input isolation to your spectrum analyzer or receiver.
During EMC measurements the antennas are usually placed at a distance of 1 -10 meters from the equip­ment under test. Most antennas operating above 1 GHz typically have high antenna factors. In addition, long interconneting cables operating in the microwave fre­quencies usually have high cable losses. These factors make it difcult to see the radiation from the equip­ment under test above the oor noise of the spectrum analyzer. The preamplier improves system sensitivity by amplifying the signals picked by the antenna before it reaches the spectrum analyzer.
The system sensitivity can be further improved by connecting the PAM-118 preamplier right at the antenna output. Placing the preamplier close to the receiving antenna will reduce the effects of high cable loss associated with long cables.
Com-Power Corporation (949) 587 - 9800 www. com-power.com sales@com-power.com
B-3
Specications
0
8
16
24
32
40
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18
Gain (dB)
Frequency (GHz)
Frequency: 500 MHz - 18000 MHz Gain: 24 dB Flatness: ± 1.25 dB Noise Figure: 3 dB, max. VSWR (Input / Output): 2.5: 1 / 2.5: 1 P
@1dB Comp: +17 dBm, minimum
out
DC Input: 0 VDC, max. Input power handling: +10 dBm, CW Reverse Isolation: 40 dB, typical Power: 18 VDC, 1 Amp Impedance: 50 Ohm Connector type: SMA Size: 7.7" x 6.5" x 3.2" (18.4 cm x 15.6 cm x 7.7 cm) Weight : 2.5 lbs. (5.5 kg) Operating Temperature + 25o C
Typical Amplier Gain
All specications are subject to change without notice. All values are typical, unless specied.
Com-Power Corporation 20621 Pascal Way, Lake Forest, California 92630 (949) 587 - 9800 www.com-power.com Rev 0102
B-4
Loading...