Component Hardware Q75-1366-352K, Q75-1366 User Manual

MATERIAL SAFETY DATA

SECTION 1. INDENTIFICATION OF THE SUBSTANCE AND MANUFACTURE

PRODUCT NAME: Q75-1366 Sound Deadener
CHEMICAL NAME: Water, Additive Blend
DATE: 8/9/2007
CAS NUMBER: N/A
EINECS NUMBER: N/A
PRODUCT CODE: N/A
SYNONYMS: Sound Dampening Compound
COMPANY NAME: COMPONENT HARDWARE GROUP, INC.

1890 Swarthmore Avenue
Lakewood, NJ 08701
Tel. [phone]
Fax. [phone]

IN CASE OF EMERGENCY IN U.S.: 800-526-3694
IN CASE OF EMERGENCY IN EUROPE: [phone]

SECTION 2. COMPOSITION / INFORMATION ON INGREDIENTS

CAS=

TLV (Units)

PEL

*Calcium Carbonate
#1317-65-3 and/or #471-34-1

10 mg/m3 (nuisance dust)

5 mg/m3(respirable fraction)
15 mg/m3(total dust)

*Hydrous Aluminum Silicate
#1332-58-7

10 mg/m3 (nuisance dust)

15 mg/m3

*Mica #12001-26-2

3 mg/m3

20 mg/m3 (nuisance dust)

HAZARDOUS INGREDIENTS:

Butyl Benzyl Phthalate
#85-68-7

Not established

Not established

*This component poses a hazard only if the liquid dries and a dust is formed.

SECTION 3. HAZARD INDENTIFICATION

PRIMARY ROUTES OF ENTRY: Skin absorption; inhalation
ACUTE EFFECTS: May cause severe eye irritation and reversible skin irritation. Prolonged skin exposure may cause dermatitis or

oil acne. Breathing mists may cause pulmonary irritation or dizziness. Excessive inhalation may produce dizziness, nausea,
headache and lack of coordination.

CHRONIC EFFECTS: Not Determined
CARCINOGENICITY: Calcium Carbonate, Hydrous Aluminum Silicate and Mica: May contain less than 0.1% of Silica Crystalline

Quartz (CAS #14808-60-7). IARC Monographs on the evaluations of the Carcinogenic Risk of Chemicals to Humans (Vol. 42, 1987)
concludes that there is “limited evidence” of the carcinogenicity of crystalline silica to humans. IARC Classification 2A.

Butyl Benzyl Phthalate: Female rats fed Butyl Benzyl Phthalate in long-term (2 year) studies conducted by the National Toxicology
Program (NTP) were reported to show an increased frequency on mononuclear cell leukemia, a common spontaneous disease in the
test strain of rat. For this reason, the NTP concluded that Butyl Benzyl Phthalate was “probably carcinogenic” for these rats. Male
rats in these studies were terminated after 6 months due to excessive treatment-related deaths. Mice fed Butyl Benzyl Phthalate (2
years) had no increase in tumors. Butyl Benzyl Phthalate has produced no genetic changes in standard tests using animal, bacterial
and yeast cells.

PRE-EXISTING MEDICAL CONDITIONS: Exposure may aggravate pre-existing respiratory or skin problems.

MATERIAL SAFETY DATA

SECTION 4. FIRST AID MEASURES

EYE CONTACT: In case of contact with material, immediately flush eyes with running water for at least 15 minutes. Seek immediate
medical attention.

SKIN CONTACT: Wash skin with soap and water. Remove and isolate contaminated clothing and shoes at the site.

INHALATION: Move victim to fresh air and call emergency medical care. If not breathing, give artificial respiration; if breathing is

difficult, give oxygen.
INGESTION: DO NOT INDUCE VOMITING. Consult a physician. If vomiting occurs spontaneously, keep head below hips to prevent
aspiration of liquid into the lungs.

SECTION 5. FIRE–FIGHTING MEASURES

FLASH POINT: > N/A
FLAMMABLE LIMITS: Not Determined

LOWER: Not Determined

UPPER: Not Determined
FIRE EXPLOSION HAZARDS: None
EXTINGUISHING MEDIA: Small Fires: Dry chemical, CO2, water spray, or regular foam. Large Fires: Water spray, fog, or regular

foam.
FIRE FIGHTING PROCEDURES: Move container from fire area if you can do it without risk. Apply cooling water to sides of

containers that are exposed to flames until well after fire is out. Fire may produce irritating or poisonous gases. Positive pressure self­contained breathing apparatus (SCBA) and structural firefighters' protective clothing will provide limited protection.

SECTION 6. ACCIDENTAL RELEASE MEASURES

SMALL SPILLS: Take up with sand or other noncombustible absorbent material and place into containers for later disposal.
LARGE SPILLS: Dike far ahead of liquid spill for later disposal.

SECTION 7. HANDLING AND STORAGE

STORAGE: Store in cool, well-ventilated area. Keep away from flames, sparks or hot surfaces.
HANDLING: Dried coating will burn, so follow good work practices when cutting or welding on or near empty containers. Never wear

contaminated clothing. Wash thoroughly with soap and water after use and before smoking or eating. Avoid excess skin contact.

SECTION 8. EXPOSURE CONTROLS / PERSONAL PROTECTION

PERMISSIBLE EXPOSURE LEVEL:

EYE AND FACIAL: Safety glasses with side shields or chemical goggles.
SKIN: Protective Gloves- Impervious gloves (Viton, PVOH, etc.)

RESPIRATORY: NIOSH-approved respirator for organic vapor and mist to control exposure where ventilation is inadequate.
VENTILATION: General and local exhaust.
OTHER: If splashing is anticipated, wear rubber apron and boots or other protective equipment to minimize contact.

SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES

BOILING POINT: 212°F (°C)

SOLUBILITY: Miscible

pH: Not Determined
PERCENT VOLATILE: 59%

VAPOR DENSITY (AIR=1): >1

VAPOR PRESSURE: (mmHg@20°C (°F)): Not

Determined

EVAPORATION RATE (BUTYL ACETATE=1): 1

SPECIFIC GRAVITY (WATER=1): 1.47
APPEARANCE & ODOR: Beige/Light Gray. Thixotropic Paste.

Mild odor.

VOC CONTENT (Theoretical, in LBS./GAL.): 12.5

SECTION 10. STABILITY AND REACTIVITY

STABILITY: Stable
REACTIVITY: Strong acids, oxidizing agents
HAZARDOUS DECOMPOSITION INGREDIENTS: Carbon monoxide, carbon dioxide, miscellaneous hydrocarbons.
HAZARDOUS POLYMERIZATION: Will not occur