Page 1
www.comodule.com
USER MANUAL IOT MODULE NB S Sharing 2.1
LTE OKAI
FCC ID: 2AQHSF0010004
Page 2
www.comodule.com
Introduction
The COMODULE IoT device is designed to be connected wirelessly into existing network infrastructure
to gather and transmit data and to be controlled remotely. It thus creates opportunities for the
physical world to be digitalized, which results in improved efficiency, accuracy and economic benefits.
This manual is intended for electric kick scooter service providers for COMODULE IoT module
integration.
Page 3
www.comodule.com
Installation
For the installation, the following equipment is needed:
• COMODULE IoT module Sharing 2.1 LTE OKAI
• Fixation plate
• Bolts for installation (come with COMODULE device)
• Compatible electric kick scooter
Installing the modules on the scooters
1. Plug the scooters to the electricity and make sure they show battery signal on the display.
2. Attach the IoT module to the scooter. Use bolts and fixation plate to fasten the module.
3. Plug the cable of the module to the cable of the scooter.
Page 4
www.comodule.com
Page 5
www.comodule.com
Interference
INSTRUCTION TO THE USER:
This equipment has been tested and found to comply with the limits for a class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
In order to maintain compliance with FCC regulations, shielded cables must be used with this
equipment. Operation with non-approved equipment or unshielded cables is likely to result in
interference to radio and TV reception. The user is cautioned that changes and modifications
made to the equipment without the approval of manufacturer could void the user's authority to
operate this equipment.
Loading...