Page 1
www.comodule.com
USER MANUAL IOT MODULE NB S Sharing 2.1
FCC ID: 2AQHSF0010003
Page 2
www.comodule.com
Introduction
The COMODULE IoT device is designed to be connected wirelessly into existing network infrastructure
to gather and transmit data and to be controlled remotely. It thus creates opportunities for the
physical world to be digitalized, which results in improved efficiency, accuracy and economic benefits.
This manual is intended for electric kick scooter service providers for COMODULE IoT module
integration.
Page 3
www.comodule.com
Installation
For the installation, the following equipment is needed:
• COMODULE IoT module Sharing 2.1
• Fixation plate
• Bolts for installation (come with COMODULE device)
• Compatible electric kick scooter
Installing the modules on the scooters
1. Plug the scooters to the electricity and make sure they show battery signal on the display.
2. Attach the IoT module to the scooter. Use bolts and fixation plate to fasten the module.
3. Plug the cable of the module to the cable of the scooter.
Page 4
www.comodule.com
Interference
INSTRUCTION TO THE USER:
This equipment has been tested and found to comply with the limits for a class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses and can radiate radio frequency energy and if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference, in which case
the user will be required to correct the interference at his own expense. The user is cautioned that
changes and modifications made to the equipment without approval of the manufacturer could void
the users authority to operate this equipment.
Loading...