Comnet FVTRDS1B User Manual

INSTALLATION AND OPERATION MANUAL

FVTRD

10-BIT DIGITAL BI-DIRECTIONAL VIDEO OR VIDEO SYNC
+ BI-DIRECTIONAL DATA

The FVTRD(M)(S)1 supports simultaneous transmission of short-haul quality

10-bit bi-directional digital video or video sync plus bi-directional data over one

multimode or single mode optical fiber. The module is universally compatible

with major CCTV camera manufacturers and supports RS232, RS422 and 2 or

4-wire RS485 data interfaces, and most major data protocols. Plug-and-play

design ensures ease of installation and no electrical or optical adjustments

are ever required. Bi-color (Red/Green) LED indicators are provided for rapidly

ascertaining equipment operating status. These units are interchangeable

between stand-alone or card mount configurations. See Figure A on Page 5

for installation instructions.

Each Data Channel is configured for the electrical interface by means of the

“DATA SELECT” switch on the front panel. Figure 4 on Page 3 illustrates the

switch settings to set the type of data for each channel.

Figure 5 on Page 4 illustrates the specific data connections for RS232, 2-Wire

RS485 and RS422/4-Wire RS485. (This last data connection also applies to

Manchester & Bi-Phase data transmission.) It also illustrates the electrical

connections between the “Customer Equipment” and the FVTRD.

See Figures 1 – 5 for complete installation details.

INS_FVTRD_REV–

02/01/10

PAGE 1

INSTALLATION AND OPERATION MANUAL FVTRD

FIGURE 1 – FVTRD TRANSCEIVER

MULTIMODE OR SINGLE MODE
OPTICAL FIBER

BLACK

BLACK WITH WHITE STRIPE

FIGURE 2 – FVTRD TRANSCEIVER

REAR PANELFRONT PANEL

Video termination Switch

Set switch to TERM (Terminate)
when video is not looping to other
video devices or is the last device
in a looping configuration.

NOTE: Remove Electrical Connector

for Rack Mount Units

TECH SUPPORT: 1.888.678.9427

INS_FVTRD_REV–

02/01/10

PAGE 2