Comnet FVT110 Series, FVR110 series, FVT110, FVR110, FVT110M Installation And Operation Manual

INSTALLATION AND OPERATION MANUAL

FVT/FVR110(M,S)1[/M]

10-BIT DIGITAL VIDEO WITH
ONE BI-DIRECTIONAL DATA CHANNEL

The ComNet™ FVT/FVR110 series is a video transmitter/receiver and data transceiver
that supports the simultaneous transmission of short haul quality 10-bit EIA RS-250C
digitally encoded video and bi-directional data over one multimode or single mode
optical fiber. The FVT110 also transmits a single bi-directional contact closure signal.

The module is universally compatible with major CCTV camera manufacturers.
Figures 6 and 7 starting on Page 4 illustrate the specific data connections for
RS232, RS422, 2 or 4-wire RS485 data transmission.

The FVT/FVR110 also supports “up-the-coax” data transmission from all major
manufacturers, utilizing time-base correction these units can achieve distances of
48km. The FVT/FVR110 supports Panasonic Proteus™, Pelco Coaxitron™ and Bosch
Bilinx™ Up-the-Coax systems.

Bi-color (Red/Green) LED indicators are provided for rapidly ascertaining equipment
operating status. Figure 10 on Page 6 describes the LED indicators for each light on
the unit.

The FVT110 and FVR110 units are interchangeable between stand-alone or card
mount configurations, or may be DIN-rail mounted by the addition of ComNet
model DINBKT1 adaptor plate. The FVT110M is stand-alone only. See Figure A on
Page 8 for mounting instructions.

INS_FVT/FVR110_REV–

10/27/11

PAGE 1

INSTALLATION AND OPERATION MANUAL FVT/FVR110(M,S)1[/M]

FIGURE 1 – FVT/FVR110 TRANSMITTER AND RECEIVER

MULTIMODE OR SINGLE MODE
OPTICAL FIBER

BLACK

BLACK WITH WHITE STRIPES

FIGURE 2 – FVT110 TRANSMITTER

REAR PANEL REAR PANELFRONT PANEL FRONT PANEL

Operating Voltage Range: 8–15 VDC
Power Consumption: 6W Max
NOTE: Remove Electrical Connector
for Rack Mount Units

FIGURE 3 – FVR110 RECEIVER

TECH SUPPORT: 1.888.678.9427

INS_FVT/FVR110_REV–

10/27/11

PAGE 2

INSTALLATION AND OPERATION MANUAL FVT/FVR110(M,S)1[/M]

FIGURE 4 – FVT110/M TRANSMITTER

MULTIMODE OR SINGLE MODE
OPTICAL FIBER

BLACK

BLACK WITH WHITE STRIPES

Operating Voltage Range: 8–15 VDC
Power Consumption: 6W Max

FIGURE 5 – FVT110M TRANSMITTER

REAR PANELFRONT PANEL

OPTICALVIDEO IN

DATA FORMAT

LEDs: LINK VIDEO DATA

GND
+Vin

INS_FVT/FVR110_REV–

10/27/11

PAGE 3