Comnet FVR107M1 User Manual

Mechanical Installation Instructions

Figure 1: Dimensions are for a standard ComNet™ one slot module.

FVT/FVR107

.156 [3.96 mm]

.313 [7.95 mm]

Installation Considerations

This fiber-optic link is supplied as
a Standalone/Rack module.
Units should be installed in dry
locations protected from extremes
of temperature and humidity.

Standalone Module:

The unit is provided with a mount­ing plate with holes for two No. 6 pan
head screws (3-mm or 3.55-mm).

Attach the module to a solid piece
of wood using two No. 6 pan head
wood screws with a minimum
penetration into the wood of
3/4 inch. (Screws not supplied)
See figure 1.

1. Determine where the module will
be installed, and ensure that there
is adequate space at both ends
for making the various cable
connections and for reading the
diagnostic LEDs.

2. Attach the module to a flat surface
using two mounting screws.

Rack Module:

The unit is designed to be installed in the ComNet 19-inch (483-mm) EIA standard card-cage rack, the C1-US,
C1-EU, or the C1-CH. Follow these guidelines to install rack cards after performing module setup procedures.

C1-US, C1-EU, or the C1-CH Card Cage Racks

CAUTION: Although the units are hot-swappable and may be installed without turning power off to the rack,

ComNet recommends that the power supply be turned off and that the rack power supply is disconnected
from any power source. Note: Remove electrical connector before installing in card cage rack.

1. Make sure that the card is oriented right side up, and slide it into the card guides in the rack until the
edge connector at the back of the card seats in the corresponding slot in the rack’s connector panel.
Seating may require thumb pressure on the top and bottom of the card’s front panel.

CAUTION: Take care not to press on any of the LEDs.

2. Tighten the two thumb screws on the card until the front
panel of the card is seated against the front of the rack.

INS_FVTFVR107_REVA

07/22/09

Page 1

INSTALLATION INSTRUCTIONS

DATA CHANNEL/DUAL OPTICAL PORT REDUNDANT

Communication Networks

3 Corporate Drive • Danbury, CT 06810 • USA
Tel: [phone] • Toll Free: 1-888-678-9427
www.comnet.net

FVT107

10-BIT DIGITAL VIDEO WITH 1 BI-DIRECTIONAL

POINT-TO-POINT CONFIGURATION

+ 8 CONTACT CLOSURES

MULTIMODE
OR SINGLE MODE
OPTICAL FIBER

BLACK WITH WHITE STRIPE

BLACK

NOTE: Remove Electrical Connector for

Rack Mount Units

WARNING: Unit is to be used with a Listed Class 2 or LPS power supply rated 9-12 VDC @ 1A.

WARNING: This unit should be installed in a restricted access location; available through the use of a lock and key or other

means of security. Access should be limited to service personnel who have been instructed about the reasons for the restrictions
to the location. Any and all precautions should be taken and controlled by the authority responsible for the location.

IMPORTANT SAFEGUARDS:

A) Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly,

the operating ambient temperature of the rack environment may be greater than room ambient.
Therefore, consideration should be given to installing the equipment in an environment compatible with
the maximum ambient temperature (Tma) specified by the manufacturer.

B) Reduced Air Flow - Installation of the equipment in a rack should be such that the amount of air flow
required for safe operation of the equipment is not compromised.

INS_FVTFVR107_REVA

07/22/09

Page 2