Comnet CNFE2002S1APoE-HO-M, CNFE2003M2PoE-HO-M, CNFE2003S2-M, CNFE2004M1APoE-HO-M Specsheet

2 Channel 10/100 Mbps Ethernet Electrical To Optical
Media Converter with Optional Power over Ethernet (PoE+)
CNFE200(X)(M,S)(1,2)[POE][HO][/M] Series
The ComNet Ethernet CNFE200X media converter series are two-channel Ethernet electrical to optical media converters with optional PoE+. These auto-negotiating devices accept two 10/100 Mbps electrical inputs and convert this to a single 100 Mbps optical output. This series of media converters are available as multimode or single-mode and one and two fiber SC and ST optical connectors. The ComNet exclusive Demux feature allows for port isolation, replicating two media converters over one fiber. The ComNet exclusive Mux feature prevents network video flooding of multicast traffic with DIP switch selection of the fiber port as a dedicated uplink path. The CNFE200(X) series can be powered by wide range AC or DC input while the CNFE200(X)POE units meet the 802.3at standard and provide 30 watts of PoE+ power, with an option for a 60 watt CNFE200(X)POEHO model. The PoE models can be powered by a sold seperately 48 to 56 volt DC power supply.
FEATURES
› Optional 30W or 60W PoE+ on ports 1 and 2
› 10/100 Mbps Ethernet
• 2 × 10/100 BASE-T/TX elec trical por ts
• 100 BASE-FX optical port
› Electrical ports support Auto-Negotiation for 10 Mbps or
100 Mbps, full duplex or half duplex data.
› Optical port supports 100 Mbps full duplex data
› Distances up to: 3 km (2 mi) Multimode
20 km (12 mi) Single Mode
› Link Fault Pass-Through feature detects if either of the
copper ports are down and triggers the optical port to switch states to indicate the failure to the head-end.
› Designed to meet full compliance with the environmental
requirements (ambient operating temperature, mechanical shock, vibration, humidity with condensation, high-line/lowline voltage conditions and transient voltage protection) of NEMA TS-1/TS-2 and the Caltrans Specification for Traffic Signal Control Equipment.
› ST or SC optical connectors
› 1 or 2 fiber design
803.2at 803.2at
› Voltage transient protection on all power and signal input/
output lines provides protection from power surges and other voltage transient events.
› No in-field optical adjustments required
› Full size units feature a contact closure output for remote
side link failure detection
› Standard size is hot-swappable rack module
› Standard size is interchangeable between stand-alone or
rack mount use – ComFit
› IEEE 802.3 compliant
› Lifetime Warranty
CONVERTER 2HARDENED
APPLICATIONS
› Optical transmission of Ethernet-compatible industrial
security access control systems, intercom systems, VOIP (Voice over IP) telephony networks, and IP-compatible CCTV camera surveillance networks
› Optical Ethernet transmission to wireless LAN access points
› Optical transmission of any Ethernet-compatible equipment
with a maximum data rate of 100 Mbps
LIFETIME WARRANTY WWW.COMNET.NET TECH SUPPORT: 1.888.678.9427
CNFE200(X)(M,S)(1,2)[POE][HO][/M] Series
Media Converter with Optional Power over Ethernet (PoE+)
SPECIFICATIONS
2 Channel 10/100 Mbps Ethernet Electrical To Optical
Ethernet
Data Rate 10/100 Mbps
IEEE 802.3 Compliant Full Duplex or Half Duplex Electrical Port/Full Duplex Optical Port
Connectors
Optical ST or SC, 1 or 2 Fibers
Power Terminal Block
Data RJ45
LED Indicators
- Optical Link/Data Activity - Electrical Link/Data Activity
- Power - Unit Status - PoE Status
Power
Operating Voltage Range Mini non PoE: 8 to 24 VDC or 22 to 27 VAC
Mini PoE: 48 to 56 VDC Standard: 8 to 24 VDC
Power Consumption 3W (without PoE load)
Fault Relay (Full Size Units Only)
Response Time 25 msec typical Output Channels 1 Rating 0-36V, 190mA (AC or DC)
PoE Pin Assignment
RJ45 ports support IEEE802.3at End-point Positive (VCC+): RJ45 pin 1, 2 (RJ45 pin 1,2 and 4,5 on 60W ports) Negative (VCC-): RJ45 pin 3, 6 (RJ45 pin 3,6 and 7,8 on 60W ports)
Electrical & Mechanical
Current Protection Automatic Resettable Solid-State Current Limiters
Circuit Board Meets IPC Standard
Size (L×W×H) Standard: 6.1 × 5.3 × 1.1 in (15.5 × 13.5 × 2.8 cm)
Mini: 4.1 × 3.7 × 1.1 in (10.4 × 9.4 × 2.8 cm)
Shipping Weight: <2 lbs./0.9 kg
Environmental
MTBF >100,000 hours
Operating Temp -40˚ C to +75˚ C
Storage Temp -40˚ C to +85˚ C
Relative Humidity 0% to 95% (non-condensing)
1
Ethernet Standards
IEEE 802.3 for 10BASE-T IEEE 802.3u for 100BASE-TX and 100BASE-FX IEEE 802.3at for Power Sourcing Equipment (PSE) and PoE
[1] May be extended to humidity with condensation conditions by
adding suffix ‘/C’
TYPICAL APPLICATION
E
CNFE2002M1B
E
Optical Fiber
(Fiber count, mode, distance
and connector type are
model dependent)
CNFE2002M1APOE/M
48 to 57 VDC
LIFETIME WARRANTY WWW.COMNET.NET TECH SUPPORT: 1.888.678.9427
LEGEND
CAT-5 CABLE
OPTICAL FIBER
PoE POWER
+ 2 hidden pages