Desk Assembly Instructions
Figure 2
Read all instructions and review illustrations before assembly.
Figure 1
WARNING
This desk is heavy. Two or more people are required
for assembly. Attempting to assemble this desk
alone may cause injury. Take care when handling
metal parts. Sharp edges may cause injury.
Tools needed for assembly:
Phillips Screwdriver
Level
1. Lock drawers. Then, with two or more people,
turn the desk upside down. Place on cardboard or
carpeted surface in order to prevent the top from being
scratched.
2. Insert a leg bracket into the leg slot as shown in
Figures 1 & 3. Note: the bracket may need to flip up
or down depending on which corner the leg is being
installed.
3. Insert the open end of the leg into the socket as shown
in Figures 2 & 4.
4. Align holes in the leg bracket with the holes in the
pedestal and install 2 #8 x 1/2" screws for each leg.
Note: See Figure 5 for hole alignment on front corners
with drawers.
5. Repeat for remaining legs.
6. Use two or more people to turn the desk upright.
7. Place in desired location and adjust leveling glides as
needed to level desk front to back and side to side.
Leg Slot
Figure 3
Figure 4
Leg Bracket
#8 x 1/2" screws
Figure 5
Return Desk Assembly Instructions
Figure 6
#8 x 3/4" screws
Top Connector Plate
1. With two or more people, turn the return desk upside
down. Place on cardboard or carpeted surface in
order to prevent the top from being scratched.
2. Follow instructions 2-5 on previous page for leg
installation.
3. Remove the top connector plate and filler block. See
Figure 6. Keep the top connector plate and screws
for the next step. The filler block can be discarded.
4. Install the top connector plate on the 30" x 66" wide
single pedestal desk using 5 #8 x 3/4" screws.
5. Use two or more people to turn the return desk
upright.
6. Place the return desk on top of the connector plate.
Align as shown in Figure 7.
7. Attach the return desk to the connecter plate using 5
#8 x 3/4" screws.
8. Use 3 screws to install the bottom connector
plate between the desk and return as shown in
Figure 8: 2 #8 x 1/2" & 1 #8 x 1/4".
Note: The #8 x 1/4" screw is pre-installed to the
bottom connector plate. This screw will need to be
removed prior to installing the bottom connector
plate. Then after the bottom connector plate is
aligned this screw can be re-installed.
9. Adjust leveling glides as needed to level desk front to
back and side to side.
Filler Block
Figure 7
30" x 66" wide single pedestal desk
Return desk
#8 x 3/4" screws
#8 x 1/4" screw
Bottom Connector Plate
Figure 8
#8 x 1/2" screws
Loading...