Page 1
INSTALLATION
MINIMUM CLEARANCES TO COMBUSTABLES
LEFT/RIGHT
TOP
BOTTOM
FRONT
REAR
*12 Inches
36 Inches
36 Inches
36 Inches
0 Inches
Top clearance is from top of the heater to ceiling or other
Bottom clearance is from the bottom of heater to surface of carpet,
* A sidewall must be at least 18 Inches away from the side of heater.
combustible material
tile or other combustible material.
-Always maintain a 36 Inch clearance from any furniture, draperies or
other combustible material.
WARNING:
If the heater is being installed in a residential garage, it must be secured firmly to the wall, a minimum of 36 inches
(457mm) above the floor. The heater must be located so that it is protected against any possibility of damage by a
moving vehicle, etc.
Raising the heater will reduce BUT NOT eliminate the possibility of lighting the vapor of any flammable liquids which
may be improperly stored or accidentally spilled. If the smell of gasoline is present, do not operate this heater until the
area has been properly ventilated.
~ 5 ~
Page 2
INSTALLATION
Heater Hook Position
Step 1 (Figure 1)
Step 2 (Figure 2)
Figure 1
Figure 2
DRY WALL: Using the screws and wall anchors
provided install into drywall as shown. Check to
insure screws are secure.
STUD WALL: Using the screws provided install into
drywall as shown. Check to insure screws are secure.
CONCRETE WALL: Drill ΒΌ inch holes, insert # 12 wall
anchors (not included) and secure to wall with #12 x 3
inch screws (not included). Check to insure screws are
secure.
Hook the heater into position. Check to insure
that the mounting hook holes have securely
attached to the screws installed in step 1.
~ 6 ~
Loading...