Comfort Company Single Foot User Manual
COMFORT FOOT / SINGLE FOOT
WARNING: Make sure all screws are tightly clamped upon completion.
Clamp On
Parts Included:
1 - Clamp Assembly
Diagram 1 (steps 1-3) Diagram 2 (step 4)
Leg rest tube
Common Loop
A
Toll Free 800.564.9248
www.comfortcompany.com
509 South 22nd Ave Bozeman, MT 59718
Loosen (do not remove) foot
1
plate clamp using Phillips head
screw driver.
Slide clamp over wheelchair foot
2
rest plate.
Adjust Comfort Foot to desired
3
position and tighten the screw
securely.
B
Footplate
Clamp
Wheelchair Footplate
Bolt On
Parts Included:
2 - ¼-20 x 1” or ¼-20 x 1 ¼ ” Screws (dimensions vary depending on size of part)
2 - ¼ ” x 1 ¼ " OD Fender Washer
Diagram 2Diagram 1
Legrest Position
A
2.75”
B
COMFORTFOOT_LIT016_12192012
Release common loop and secure
4
tightly around leg rest tubing.
Depending on the wheelchair,
common loop will have to be
tightened around either position
(A) or (B) as seen in the diagram.
Place template on the wheelchair
1
footplate in the desired position.
Drill two 5/16” diameter holes
2
through the footplate of the
wheelchair as marked on the
template.
Screw two ¼-20 x 1” or ¼-20 x
3
1¼ ” bolts (depending on thickness of the footplate) with the
provided washers from the
bottom of the footplate into the
Molded Foot Base.
Release common loop and secure
4
tightly around leg rest tubing.
Depending on the wheelchair,
common loop will have to be
tightened around either position
(A) or (B) as seen in the diagram.
COMFORT FOOT
BOLT-ON TEMPLATE
.
Loading...