Comfort Company Sideminder Headrest User Manual

SIDEMINDER

WITH HEADREST

®

Toll Free 800.564.9248 www.comfortcompany.com 509 South 22nd Ave Bozeman, MT 59718

www.comfortcompany.com

IS-SIDEMINDERHEADREST

REV0413

®

SIDEMINDER WITH HEADREST

SideMinder

® assembly should be installed to the chair before attaching the headrest assembly.

Parts From Kit Bag Needed:

F: (4) ¼”-20 x .875” Screws

J: (3) 10-32 x .75” Screws

(1) 3/16” Allen Wrench

(1) 5/32” Allen Wrench

(1) 5 mm Allen Wrench

(1) 3 mm Allen Wrench

Open Quick Release toggle (A) and separate the mounting plate (B) from the main headrest post (C).

1

Attach the mounting plate (B) to SideMinder

2

supplied 3/16” allen wrench. Center the mounting plate (B) in the middle of the SideMinder® (D) as shown.

Attach the headrest pad (G) to the headrest ring (H) using the supplied (3) screws (J) and 5/32” allen

3

wrench.

Insert the main headrest post (C) into the mount plate (B) at the desired height and close the quick

4

release toggle (A).

® (D) using (4) screws (F), the back clamp half (E), and the

J

C

K

H

E

G

F

Loosen the bolts at each joint (K) with the supplied 5 mm allen wrench to adjust the headrest pad to the

5

desired location and then tighten each bolt firmly.

When the main headrest assembly is at the correct height, lower the collar (L) to rest above the mount

6

plate (B) and tighten the collar set screw with the supplied 3 mm allen wrench. This will ensure the
headrest is returned to the correct position after it is removed for transfers.

L

D

B

A