Comfort Company Sideminder Arms User Manual

Toll Free 800.564.9248

www.comfortcompany.com

509 South 22nd Ave Bozeman, MT 59718

SIDEMINDER WITH ARMS AND SUPPORT PADS

®

Support pads come in 2 shapes: standard (7003) and contoured (7004) as shown below.
SideMinder® assembly should be installed to the chair before attaching the arms and support pads.

Parts from Kit Bag needed:
F: (4) ¼”-20 x .75” Philips Pan Head Screws

7004 SUPPORT PAD

7003 SUPPORT PAD

E

D

For each quick release toggle (A): Open the

1

toggle, and while holding the toggle in place,
begin tightening the toggle nut (C) until
finger tight.

Insert the telescoping arms (B) into the tube

2

openings (D).

Adjust the telescoping arms (B) to the desired

3

distance and angle.

A

C

B

Close the toggles (A) to clamp down on the

4

telescoping arms (B).

Note: If the telescoping arms can still move with the toggles
closed, open the toggles and remove the arms. Then repeat
steps 1-4.

Lift the cover flap on the support pads (E) and

5

attach the pads to the telescoping arms (B) using
the provided pan head screws (F).

Adjust pads to the desired distance and angle

6

and then firmly tighten the screws.

F

IS-SIDEMINDERARMS

REV0413