Comfort Company Sideminder User Manual
SIDEMINDER
®
Toll Free 800.564.9248 www.comfortcompany.com 509 South 22nd Ave Bozeman, MT 59718
www.comfortcompany.com
IS-SIDEMINDER
REV0413
®
SIDEMINDER
Parts From Kit Bag Needed:
(1) 5 mm Allen Wrench
Loosen clamp screws (A) using the supplied 5 mm allen wrench to open the cane clamps (B). Do not
1
remove the screws, leave loose enough to clamp around the wheelchair canes.
Loosen tube screw (C) using the supplied 5 mm allen wrench to allow the tube assembly (D) to slide
2
freely for width and rotational adjustment.
Attach cane clamps (B) to wheelchair canes by finger tightening the clamp screws (A).
3
Note: Leave loose enough for height and leveling adjustments.
4
5
6
7
8
9
10
Make sure cane clamps (B) are level with each other and angled straight back.
Release inside toggles (E) to allow the tube assembly (D) to be removed from the clamp assembly (F).
Minor rotational adjustment of the cane clamps (B) and the tube assembly (D) may be needed in order for
the tube assembly (D) to slide in and out smoothly.
Once the tube assembly (D) can be inserted smoothly, firmly tighten the tube screw (C) while holding the
center of the tube assembly to prevent the tubes from sliding or rotating.
Note: If the tubes slide or rotate during tightening, loosen the screw, remove the tube assembly, and repeat steps 6-7.
Firmly tighten the clamp screws (A) one side at a time while holding the clamp assembly (F) in place to
prevent vertical movement and rotational movement about the cane.
Once all screws are tightened, check to see if the tube assembly (D) can still be removed and inserted
smoothly.
Note: If not, loosen all the screws and repeat steps 6-9.
Close both inside toggles (E) to secure SideMinder
® assembly.
D
C
E
A
B
F
Loading...