Comfort Company Removable Solid Seat Pan Standard User Manual

Toll Free 800.564.9248

www.comfortcompany.com

509 South 22nd Ave Bozeman, MT 59718

REMOVABLE SOLID SEAT PAN - STANDARD

PARTS INCLUDED:

1 - Removable Solid Seat Pan Assembly
1 - 5/32” Allen Wrench
1 - RSSP Kit Bag*

*For any sizing/fitting discrepancies with
cane mounts, please attach the smaller
cross members that are provided in the
RSSP Kit Bag (image of part shown below).

A

B

H

C

F

B

G

H

D

E

Remove existing seating hardware from the

1

wheelchair.

Take removable solid seat pan assembly (G) from

2

packaging.

Loosen (but do not remove) bolts (A) and (B) using

3

the provided 5/32” Allen Wrench.

Adjust the hooks (H) in or out to properly center

4

the seating pan on the wheelchair support rails (E).

Securely tighten bolts (A) and (B) to fasten the

5

hooks (H) into place.

6

7

8
9

10

Place each of the four plastic securing clips (D)
on the wheelchair support rails (E) to the inside
of each hook (H).

NOTE: There is a removable plastic insert in the securing
clips to allow for use on various diameters of wheelchair
support rails.

Lift solid seat pan assembly off of the wheelchair
support rails and set it aside.

Fasten the plastic securing clips into place with
the screws (F) and a Phillips screw driver.

Reposition the solid seat pan assembly back onto
the wheelchair support rails.

Slide the plastic arm on the plastic securing clips
(D) over the hooks (H) to lock the solid seat pan
into place.

IS-REMOVABLESOLIDSEATPANSTANDARD

REV0413