Comfort Company Flexion Footbox Double User Manual

FLEXION FOOTBOX

™

- DOUBLE

Toll Free 800.564.9248 www.comfortcompany.com 509 South 22nd Ave Bozeman, MT 59718

www.comfortcompany.com

IS-FLEXIONFOOTBOXDOUBLE

REV0413

FLEXION FOOTBOX™ - DOUBLE

Parts Included:

Pre-Attached

2 - (A) Screw 1/4-20 x 1/2” Button Head
2 - (B) Washer 0.25” ID, 0.75” OD

From Kit Bag

1 - (C) Allen Wrench 5/32
4 - (D) Screw 1/4-20 x 1.25” Phillips Pan Head
4 - (E) Screw 1/4-20 x 1” Phillips Pan Head
4 - (F) Washer Internal Tooth, 5/16” ID
8 - (G) Washer 0.25” ID, 1.25” OD
4 - (H) Nut 1/4-20 Nylon Lock

Remove center foam/cover piece.

1

Place the Flexion Footbox on the wheelchair footplates in the required position.

2

FIGURE 1: MOUNTING HOLES

DRILL MOUNTING HOLES

FIGURE 2: HARDWARE ATTACHMENT

Drill 4 mounting holes through the bottom of the wheelchair footplates and through the bottom

3

of the Flexion Footbox plate as shown in Figure 1. Holes must be big enough for a ¼”-20 screw.

Attach the Flexion Footbox to the foot plates with screw (D or E) depending on the thickness of

4

the foot plates; along with the washer (F), washers (G), and nut (H) using Allen Wrench (C) as
shown in Figure 2.

Reattach the center foam/cover piece.

5

Remove screw (A) and washer (B) on both sides using Allen Wrench (C) as shown in Figure 2.

6

Adjust the angle of the Flexion Footbox to the required position as shown in Figure 3 and then

7

reattach screw (A) and washer (B) to lock the Flexion Footbox in place.

D OR E

F

G

H

FIGURE 3: ANGLE ADJUSTMENT

90

B

A

160