Comfort Company Comfort Foot Single User Manual

COMFORT FOOT SINGLE

WARNING: Make sure all screws are tightly clamped upon completion.

Clamp On

Parts Included:

1 - Clamp Assembly

Diagram 1A (steps 1-3) Diagram 2A (step 4)

Leg Rest Tube

Side
Strap

C

A B

Top View

Toll Free 800.564.9248

www.comfortcompany.com

509 South 22nd Ave Bozeman, MT 59718

Loosen (do not remove) footplate

1

clamp bolt using Phillips head
screw driver.

Slide clamp over wheelchair

2

footplate as seen in Diagram 1A.

Adjust Comfort Foot Single angle

3

to desired position using base
straps and tighten clamp bolt
securely.

Base Straps

Footplate
Clamp & Bolt

Leg Rest
Tube

Wheelchair Footplate

C

Bolt On

Parts Included:

2 - ¼-20 x 1” or ¼-20 x 1 ¼ ” Screws (dimensions vary depending on style of part)
2 - ¼ ” x 1 ¼ " OD Fender Washer

Diagram 2B (step 5)Diagram 1B (steps 3-4)

Side
Strap

C

A B

Side
Strap

Leg Rest
Tube

Base Straps

Top View

C

Release side strap and secure

4

tightly around leg rest tubing (C).
Note: Depending on the wheel­chair, strap will have to be tight­ened in either configuration (A)
or (B) as seen in Diagram 2A.

Place the provided template on

1

the wheelchair footplate in the
desired position.

Drill two 5/16” diameter holes

2

through the footplate as marked
on the template.

Adjust Comfort Foot Single to

3

desired angle using base straps.

Screw two ¼-20 x 1” or ¼-20 x

4

1 ¼ ” bolts with the provided
washers from the bottom of the
footplate into the Comfort Foot
Single base. Note: Use 1“ bolts
for Comfort Foot Single with Gel.

Release side strap and secure

5

tightly around leg rest tubing (C).
Note: Depending on the wheel­chair, strap will have to be tight­ened in either configuration (A)
or (B) as seen in Diagram 2B.

IS-COMFORTFOOTSINGLE
REV0814

®

Comfort Foot Single

BOLT-ON TEMPLATE

.