Comfort Company Comfort Foot Double User Manual

COMFORT FOOT DOUBLE

WARNING: Make sure all screws are tightly secured upon completion.

Bolt On

Parts Included:

2 - ¼-20 x 1” or ¼-20 x 1 ¼ ” Screws (dimensions vary depending on style of part)
2 - ¼ ” x 1 ¼ " OD Fender Washer

Toll Free 800.564.9248

www.comfortcompany.com

509 South 22nd Ave Bozeman, MT 59718

Base

Comfort Foot Double with Leg Separator shown

Place the provided left or right footplate template

1

on the wheelchair footplate in the desired position.

Drill two 5/16” diameter holes through the footplate

2

as marked on the template.

Adjust Comfort Foot Double to desired angle using

3

base straps (A).

E

A

B

C

D

Wrap footplate straps (D) around wheelchair

5

footplates and secure using side-release buck­les.

Wrap rear strap (E) around leg rest tubing and

6

secure with side release buckle. Tall style uses
two rear straps to secure.

Screw two ¼-20 x 1” or ¼-20 x 1 ¼ ” bolts* with the

4

provided washers into position (B) for left side or (C)
for right side from the bottom of the footplate into
the Comfort Foot Double base. *Note: use 1“ bolts
for Comfort Foot Double with Gel.

Bolt on installation with securing buckle allows the Comfort
Foot to swing away for patient transfers. Note: product can
be installed with securing buckles only.

IS-CFDOUBLEBOLTON
REV0814

®

Comfort Foot Double

BOLT-ON

(for right footplate)

2.75 “

TEMPLATE

Place template on the wheelchair footplate in the desired position.

1

Drill two 5/16” holes using the template above.

2

IS-CFDOUBLEBOLTONRIGHT

REV0814