Comet Innovation S2 User Manual

S2

DUAL SPEAKER SYSTEM

The Langie is equipped
with built-in high quality
dual Speakers, one on
the rear that the other
people can hear clearly
what you said.
One on the front that
you can hear clearly
what the other said.

VOLUME

** Press the Volume key
(+) to louder, (-) to lower.
** It displays a volume
dialog box to indicate
the volume level.

POWER BUTTON
ON/OFF
** Turn ON --

Press and hold the power
button for about 5 seconds
until you see the display turning
On.

** Turn OFF -- Press and
hold the power button for
about 2 seconds to display
the shutdown dialog box,
tap POWER OFF to shut down.
** Press the power button
for sleep mode (off the
LCD) when not in use.

FCC StatementFCC Statement

This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: 1) this device may not cause harmful interference, and 2)
this device must accept any interference received, including interference that may
cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

--Reorient or relocate the receiving antenna.

--Increase the separation between the equipment and receiver.

--Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

--Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.

RF Exposure Statement

RF Exposure Statement

SAR tests are conducted using standard operating positions According FCC standard with the
device transmitting at its highest certified power level in all tested frequency bands, although
the SAR is determined at the highest certified power level, the actual SAR level of the
device while operating can be well below the maximum value.
This model product has been tested and meets the FCC RF exposure guidelines with the test
distance 5mm for body worn. The use of belt clips, holsters and similar accessories should not
contain metallic components in its assembly. The use of accessories that do not satisfy these
requirements may not comply with FCC exposure requirements, and should be avoided