This antenna bracket is for installation
on these specific vehicles:
Ford Explorer 2020 +
(Install instructions on reverse side)
Chevrolet Silverado 1500: 2014-2019
Silverado 2500, 3500: 2016-2019
GMC Sierra 1500: 2014-2019
GMC Sierra 2500, 3500: 2016-2019
Tools Required:
Model#: CV2ANTNCG
13mm socket and
driver, or 13mm box
end wrench
Install location:
Left front fender
Please Read: Always check for continuity between the bracket and chassis ground. If there is a
problem with grounding, place the provided star washer between the bracket and the fender.
Step 1) Set the parking brake. Open hood and locate 13mm bolt near the back of the front fender.
Remove bolt.
Step 2) Align the antenna bracket with the bolt hole. Reinstall the bolt and tighten.
Step 3) Insert the NMO or required connector to mate with the antenna and tighten securely keeping in mind that NMO mounts are designed to be installed from the top.
NCG Company may not be held liable for any damage to the vehicle before, during or after the installation or removal of this antenna bracket.
NCG may not be held liable for any personal injury resulting from accident or improper installation.
National Communications Group Co., Ltd
Chino, CA 800-962-2611
909-393-6133 Fax: 909-393-6136
www.natcommgroup.com
Tools Required:
10mm socket and
driver, or 10mm
box end wrench
Install location:
Left front fender
Installaion instructions for the 2020
FORD EXLORER
Model#: CV2ANTNCG
The fender bolt is located under the panel at the front left
corner of the engine
compartment.
Remove the clips that hold the panel in place to
gain access to the fender bolt. Once the bracket
is installed and bolted down, replace the clips
that hold the panel in place.
Please Read: Always check for continuity between the bracket and chassis ground. If there is a
problem with grounding, place the provided star washer between the bracket and the fender.
Step 1) Set the parking brake. Open hood and locate the 10mm bolt near the windshield of the
front drivers side fender. Remove bolt.
Step 2) Align the antenna bracket with the bolt hole. Reinstall the bolt and tighten.
Step 3) Insert the NMO or required connector to mate with the antenna and tighten securely
keeping in mind that NMO mounts are designed to be installed from the top.
NCG Company may not be held liable for any damage to the vehicle before, during or after the installation or removal of this antenna bracket.
NCG may not be held liable for any personal injury resulting from accident or improper installation.
National Communications Group Co., Ltd
Chino, CA 800-962-2611
909-393-6133 Fax: 909-393-6136
www.natcommgroup.com
Loading...