COMENDA GE605 rcd, GE755 rcd, GE1005 rcd, GE1255 rcd, GE805 rcd Instruction Manual
INSTRUCTION
INSTRUCTIONINSTRUCTION
INSTRUCTION
MANUAL
MANUALMANUAL
MANUAL
FOR
FORFOR
FOR
POT WASHING
POT WASHINGPOT WASHING
POT WASHING
-------------------------------------------------------------------------------------------------------------------------------------------------
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
-------------------------------------------------------------------------------------------------------------------------------------------------
Mod.
Mod.Mod.
Mod.
GE605 rcd
GE605 rcdGE605 rcd
GE605 rcd
GE755 rcd
GE755 rcdGE755 rcd
GE755 rcd
GE805 rcd
GE805 rcdGE805 rcd
GE805 rcd
GE1005 rcd
GE1005 rcdGE1005 rcd
GE1005 rcd
GE1255 rcd
GE1255 rcdGE1255 rcd
GE1255 rcd
INSTRUCTIONS FOR THE USER
2
FOREWORD
1. Read the instructions contained in the present booklet carefully, because
they supply important information on installation, operation and
maintenance safety. Store this booklet carefully for any further
consultation by other operators.
2. Having removed the packing material, check that all the equipment is
present.
If there is any doubt, do not use it and contact qualified personnel.
The packing elements (plastic bags, foam polystyrene, nails, etc.) should
be kept away from children, because they are dangerous.
3. Before switching the equipment on, make sure that the model plate data
conforms to that of the electrical and water distribution network.
4. Installation should be carried out by qualified personnel according to the
manufacturer's instructions.
5. This equipment should be destined to the use which it has been conceived
for. Any other application should be considered improper and
consequently dangerous.
6. The equipment should only be used by personnel trained for its use.
7. Operators must strictly follow all hygienic requirements in the handling of
clean dishware and cutlery.
8. Do not leave the machine in an environment at temperatures lower than
0°C.
9. The protection of the machine is IP X4, therefore it should not be washed
with high pressure directed water jets.
10.Qualified personnel only can access the control panel, after having
disconnected the machine from the primary current supply.
11.The appliance is made according to EEC 89/336 regarding radio noise
suppression and electromagnetic compatibility.
12.According to EEC directive nr.23 of 19/02/1973 and the law of actuation
nr.791 of 18/10/1987, our appliances are built-up according to the good
technique norms in force in Italy and abroad.
13.Noise level of the machine, less than 70dB(A)
INSTRUCTIONS FOR THE USER
3
INSTRUCTIONS FOR USE
INSTRUCTIONS FOR THE USER
4
CONTROL PANEL
CONTROL PANELCONTROL PANEL
CONTROL PANEL
Q1
Main switch
H14
Pilot lamp " check "
H9a-b-c
Pilot lamp "cycle"
H2
Pilot lamp "machine ready"
S3
Push button "WASH or DRAIN CYCLE START"
S9
Cycle selector / AUTOMATIC or MANUAL startup
T2 B
oiler thermometer
T3
Tank thermometer
INSTRUCTIONS FOR THE USER
5
OPERATION AND USE
1. Before washing make sure that:
• the wall-mounted on/off switch is switched on;
• the water tap is open;
• water is present in the distribution network;
• the pump protection filters are installed in their respective positions;
• the overflow in inserted;
• all rotating parts are free;
• the rinse aid dispenser is full;
• make sure that dishware is in good conditions as it may cause cleaning
difficulty and haven bacteria.
2. Press the "Q1 on/off" button ("H14" ON) to enable the automatic wash
tank filling and the consequent triggering of the heating element.
Wait that the temperatures are 55°C for washing "T3" and 80-85°C
for rinsing "T2" (the lamp"H2" ON).
3. Pour about 30 gr. of detergent directly into the tank, paying attention to
distribute it uniformly on the filters, the quantity being according to
supplier's instructions. Add 15 gr. every 4 cycles to achieve a concentration
of 1,5 gr./lt. In order to respect our environment, use only the correct amount
of detergent.
When using chlorinated detergent, it is suggested to use an automatic
dispenser; otherwise, brownish spots might appear on the surfaces due to
chlorine reactions. Detergent should always be placed near the pump filter.
4. Then, introduce the glasses or the cups to wash, after having removed the
solid waste and having placed them into the proper racks. The cups and the
glasses should be turned upside down, while the cutlery should be put
vertically into the proper container, and the same applies to dishware.
Loading...