COMBI International Corporation ••199 Easy St. ••Carol Stream, IL 60188 ••www.combi-intl.com
Customer Service 1-800-992-6624 ••10:00 a.m. - 5:00 p.m. Central Standard Time ••Monday - Friday
- 3 -
1. The canopy
comes with a
small pocket on
each side. Insert
a speaker in
each pocket.
2. The canopy has
a storage pocket
in the back. Place your
portable CD, cassette, minidisc or MP3 player inside
the back pocket.
3. Insert the (2.8mm) mini plug
into the player. Turn on your
player.
CAUTION
Be sure to test the volume on your player. Set it at a comfortable level so
that it does not startle your baby when turning it on. Loud volume can
hurt your baby’s ears. If you notice that the sound has become weak or
distorted or if tracks do not change, this is an indication that your
batteries are low. Replace the batteries and set the volume at a comfortable level.
CAUTION
Before folding your stroller, be sure to remove your
player from the back pocket of the canopy.
This will make it easier to fold the stroller.
When you fold the stroller, you may leave the speakers in the
Acoustic Canopy, but only for short periods of time.
In the summer, the temperature may get as high as 212°F/100°C or
more. Do not leave your stroller, with the speakers in the Acoustic
Canopy pockets, in your car trunk where the temperature may
reach high levels. Store speakers in a cool and dry area.
Installing the Speakers
WARNING:
To avoid serious injury keep stereo speakers and
cords out of reach of children.
4
Attaching the Canopy
1. Place the rear axle and
rear wheel holders in
front of you with the leg
opening facing up and
the brake levers toward
you. Slide each wheel
holder onto the axle.
2. Place each wheel on the axle with the brake projections to the inside.
3. Place a washer on the axle, on the outside of each wheel. (In some
instances, more than one washer on each side may be necessary to
take up free play. If binding is noted, remove one of the washers.)
4. Push the straight end of the pin through the hole in each end of the axle
to lock the wheels and holders in place (See Figure A).
5. Cover the exposed axle ends with wheel caps.
6. Lay the stroller on its front with the rear legs up. (See Figure B). Slip
the rear wheel holders with the brake levers facing up onto the rear legs
until they click into place.
Figure A
Pushing the pin
Figure B
Attaching the rear
wheel unit to the
main body
3
Rear Wheels
1. Confirm the canopy is facing in the proper direction.
2. Fully insert the canopy holder (male) to the canopy
holder (female) until a click is heard.
3. Fasten the velcro located on both sides around the
handle.
Removing the
Canopy
Pull the velcro
apart, squeeze the
bottom of the
canopy holder
(male) and pull the
canopy off.
CAUTION
Failure to fully secure the canopy holders can cause the holders to bend.
When storing the stroller by laying it down, be sure the canopy is off
the ground to prevent it from bending.