fully extend the
handle by pushing
handle adjuster
buttons and
rotating the handle
to upright position.
2. Pull the lock lever
out to release the
stroller.
3. Lift the handle and snap the stroller away from
Front Wheel and Footrest Assembly
1. Lean stroller back and slide the footrest
onto the two front stroller legs (figure A)
until both upper pins snap in place (figure
B). Pull down on footrest to ensure it is
secure.
2. With footrest in place, slide wheels onto
the two front stroller legs until both lower
pins snap in place (figure C). Pull down on
wheel to ensure it is secure.
you. It will open and automatically lock into
position.
Lower Pins
Figure A
Upper Pins
Removing the front wheel and footrest:
1. Press in the two lower pins that secure the
front wheel while sliding the wheel off of
the stroller leg (figure D).
2. Press in the two upper pins holding the
footrest while sliding the footrest off of the
stroller leg (figure E).
Figure CFigure DFigure E
- 3 -
Figure B
Upper Pins
Rear Wheel Assembly
1. Insert wheel into rear axle (figure A)
until it clicks into place. Pull wheel
out to ensure it is secure.
2. Repeat this step with the opposite
side.
Figure A
Removing the Rear Wheels
Press the release lever as shown in
Figure (B) while pulling the rear wheel
away from the stroller.
Attaching the Canopy
1. Ensure the canopy is facing the proper direction.
2. Fully insert both sides of the canopy (male) into
each side of canopy holders (female).
3. Attach the velcro located on each side of the
canopy around the stroller handle.
Removing the Canopy
Pull the velcro apart, squeeze the bottom of
the canopy holder (male) and pull the
canopy off.
Figure
B
CAUTION
Failure to fully secure the canopy holders can
cause the holders to bend. When storing the
stroller by laying it down, be sure the canopy is
off the ground to prevent it from bending.
Attaching the Kid's Tray
Attaching the Kid's Tray
Push the Kid's Tray into
the guardrail posts on the
armrest until they lock in
place. Check to make sure
each side is firmly attached.
Removing the Kid's Tray
Press the buttons on each
side of the armrest while
pulling the Kid's Tray away.
WARNING
Pull on each side of the Guardrail to make
sure that it is completely attached. Do not
lift the stroller by the Guardrail.
-4 -
Attaching the Parent Tray
WARNING
Holding the Parent Tray with the center
compartment facing toward you, align
the tongue from both sides of the Parent
Tray to the groove on the handle, located
opposite the handle adjuster buttons.
Slide Parent Tray down until it clicks into
place and then pull up on it to be sure it
is secure.
Using the Rear Brakes
To lock brakes, push both brake levers DOWN.
To unlock brakes, push both brake levers UP.
TO AVOID BURNS, never place hot liquids in
the Parent Tray. To prevent tipping, DO NOT
place more than 3 lbs. on the Parent Tray.
Removing the Parent Tray
Locate the tabs underneath the Parent
Tray, on each side of the tray. While pulling the tab out toward the adjuster button, push the Parent Tray upward.
CAUTION
Push the stroller forward to
ensure that the brakes are
properly engaged.
Using the Reclining Backrest
1. Press the lever at the top
of the seat to the left.
2. Adjust the backrest gently
to any of three positions.
To return the backrest to the
upright position, simply lift the
backrest gently into place.
Using and Adjusting the 5-point Harness
1. Place the crotch belt between the baby’s legs.
2. Insert both waist belt buckles into the middle plastic piece.
WARNING
Never use seat in reclined position unless the
permanently attached safety cover is used.
CAUTION
Be careful when reclining the backrest
while your baby is in the stroller to prevent
abrupt changes in seating position.
CAUTION
Avoid serious injury from falling or
sliding out. Always use harness.
- 5 -
3. Attach each shoulder strap’s
hook to the top of the waist
belt clips.
4. To adjust the harness or waist
belt, loosen the slack on
both sides of each buckle.
Removing/Attaching the Seat Cushion
Removing
1. Unbuckle the 5-point harness and pull all the straps
through the seat cushion.
2. Grasp the seat cushion at the top and unfasten from the
velcro.
Attaching
1. Pass the 5-point harness straps through the appropriate
locations in the seat cushion.
2. Fasten the velcro.
Folding the Stroller
1. Raise the backrest to the upright position.
CAUTION
If seat cushion is ripped or torn,
do not use. Do not use the stroller
without the seat cushion.
Figure A
2. Fold the canopy by lifting the canopy levers.
3. Lift up and hold the Folding Levers located on each side
near the top of the handle as shown in the Figure (A).
Then, tilt the stroller backward until it starts to fol
4. Grasp the guardrail and handle in opposite hands and
pull together.
5. Engage the folding latch on the side of the stroller as
shown in the Figure (B).
6. Rotate handle to fold position as shown in the
Figure (C).
d.
Figure
Folding Levers are
located below the
handle adjuster
buttons on each side
of the handle.
B
Folding
Latch
Figure C
-6 -
Using the Safety Cover (Boot)
Velcro
Installing the Safety Cover (Boot)
1. Lift the seat cushion and pull safety cover
(boot) out.
2. Place the safety cover (boot) over the guardrail
and secure it with the velcro.
WARNING
Child may slip into leg openings and strangle.
Never use in reclined carriage position(s) unless
safety cover (boot) is securely fastened.
CAUTION
Before folding the stoller, unfasten and
store the safety cover (boot) under the
seat. The stroller will not fold with it
attached.
Travel System
WARNINGS
NOTE:
Make sure you use the
Combi Centre Connectors
provided with the stroller.
When the Combi Centre
Infant Car Seat/Carrier is in the
stroller, always lock into the Combi
Centre Connectors.
Discontinue use if the Combi
Centre Connectors are damaged.
The Kids Tray must be attached
when attaching the Combi Centre
Infant Car Seat / Carrier
.
If unable to securely attach
Combi's Centre Infant Car Seat/Carrier
using the Combi Centre Connectors,
discontinue use and contact
Combi Consumer Affairs.
Do not carry stroller by using
Combi Centre Infant Car Seat/Carrier
handle.
- 7 -
Using the Travel System
CAUTION
Pull on each Combi Centre Connector to ensure
they are secure.
ATTACHING the Combi Centre Connectors and the
Combi Centre Car Seat.
1. Undo the Velcro armpad and lay it accross the
stroller seat cushion.
2. Snap on the Combi Centre Connectors to the
armrail. Make sure the Combi Centre Connectors
are in the correct position with the slotted grove
facing in. Pull up on the Connectors to ensure
they are locked.
3. Recline the backrest to the middle or lower
position.
4. Fold back the canopy and align the Combi Centre
Car Seat with the Connectors. Be sure the car
seat is facing the correct direction with the back
facing the snack tray. Push the car seat down into
the connectors until you hear both sides lock into
the Connectors.
5. Lift up on the Combi Centre Car Seat to ensure
that it is securely attached to the stroller.
-8 -
Removing the Combi Centre Car Seat from the Stroller
1. Locate the release lever and pull upward to unlock
the Combi Centre Car Seat from the Connectors on
the Stroller.
2. While pulling on the release lever, pull the Combi
Centre Car Seat up using the car seat handle until
both sides release from the stroller Connectors.
- 9 -
Routine Maintenance
STORE IN A COOL AND DRY AREA, especially in the summer. Do not store the stroller in the trunk of
a vehicle.
SEAT CUSHION
The seat cushion is machine washable. Set to gentle cycle using warm water and a mild detergent. Do
not use bleach. Lay seat cushion and canopy and car seat covers flat to dry in shaded area. Do not
machine dry. To prevent color fading, do not leave soaking for a long period. If the seat cushion is
frayed or unraveling, discontinue use and call Consumer Affairs for further instruction.
CANOPY, SEAT BELT, FIXED BASE SEAT, TRAVEL BAG, STROLLER PACK AND BASKET
Hand wash with a soft brush. Wipe out excess water with a dry cloth and dry in a shaded area. For
stubborn dirt, dilute a mild detergent then apply directly to the dirty area. Wipe out the detergent.
MAIN BODY
Briskly wipe off any mud and dirt. To clean the body, wipe with a damp cloth then wipe out any traces
of moisture on the body with a dry cloth. The main body might become moldy and musty if not wiped
dry. Excessive exposure to the sun could cause premature color fading of stroller plastic and fabric.
WHEEL ASSEMBLIES
After prolonged normal use, the wheels of your stroller may not swivel or turn as easily as when the
stroller was new. This is usually due to a buildup of dirt in the swivel mechanism. Before adding lubri
cation, remove the swivel wheels by pressing the release button and wiping off mud and dirt. Do not use soap and water to wash wheels. Periodically check that all screws, bolts and nuts are tight.
-
Avoid lubricating the swivel wheels whenever possible. Excessive lubrication or adding lubricant to
swivel wheels when new may cause them to develop a shimmy or wobble that may quicken their dete
rioration. Add silicone* to the wheel assemblies in small amounts.
Do not use lubricants because oil attracts dust and
would hinder the movement rather than improve it.
*Silicone spray is available in varying size cans at most hardware stores.
Trouble Shooting
STROLLER WILL NOT FOLD
- Check to see that the attachment strap is not caught in the side.
- Make sure front swivels are locked.
- Remove all items from the basket.
- Make sure the seat back is in the upright position.
DIFFICULT TO STEER/STROLLER PULLS TO ONE SIDE
- Remove any items hanging from the handle.
- Make sure weight in basket is distributed evenly.
- Check that the brakes are not in the locked position.
- Clean and add silicone to wheels, if necessary.
DIFFICULT TO GET UP CURBS
- Pulling stroller backward makes going
up a curb difficult, and could pose a safety hazard.
Pull the handle up to lift the rear wheels
onto the curb, then pull the stroller backward
until the front wheel clears.
DIFFICULT TO GET DOWN CURBS
- Turn stroller around, bringing rear wheels toward the edge of the curb. Gently
lower rear wheels onto the surface below. Once the rear wheels have landed, guide
the front portion of the stroller, using the armrest as support.
-
Rear Wheel
Front Wheel
Note: Illustrations are for
reference only and may not
represent the actual product.
-10 -
- 11-
Combi IV7735 Series
Instruction Manual
If you would like to place an order for the following parts, please fill out the form below and return
it to the following:
Combi USA, Inc.
Attn: Consumer Affairs Department
1962 Highway 160 W, Suite 100
Fort Mill, SC 29708-8027
IMPORTANT: We must have this information to process your order:
Model Number: 7735 - ____ Color & Pattern of Fabric:______________________________________________________
Parts List
Price Quantity Total
or Fax this completed form to us at
803-548-3663
1. Seat Cushion $ 35.00
Basket $ 20.00
2.
3. Canopy $ 35.00
4. Kid's Tray $ 20.00
5. Shoulder Pads $ 10.00/set
6. Combi Centre Connectors $ 10.00
7. Rear Wheel Assemblies (Left And Right) $ 20.00/set
8. Front Wheel Assembly $ 20.00
If you need to order other parts for your stroller, please call us tollfree at 1-800-992 -6624.
Combi USA reserves the right to change pricing at any time.
Shipping & Handling
Shipping and Handling Fees: Add $8.00 for orders $34.99 and under. Add
$13.00 for orders $35.00 and over. Note: Additional shipping charges will
Sales Tax (6%)
apply outside of the Continental U.S.
(SC residents only)
Combi USA reserves the right to change pricing at any time.
Ship To:
Total
Amount of Order
ADD
Charge to my credit card:
Consumer Name
VISA MASTERCARD
AMERICAN EXPRESS DISCOVER
Street Address
Card Number
Street Address
City, State, Zip
Telephone Number
Combi USA, Inc. • 1962 HWY 160 W, Suite 100 • Fort Mill, SC 29708 • www.combi-intl.com
Consumer Affairs 1-800-99-Combi
Expiration Date __________ - ___________ -
Cardholder’s Signature
Check enclosed
____________
10/24/05
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.