1. Press the pivot
buttons in and
raise pivot
handle.
2. Place one hand
Attaching the Rear Wheels
on the handle and
one hand on the
seat. While grasp
ing the handle,
push the seat
away from the
handle until the
stroller opens
entirely and locks
into the opened
position.
-
4. Pull the basket frame until it
clicks and locks into place.
Note: The basket locks into a fixed
position and is not moveable.
1. Stand behind the stroller.
2. Locate the small chrome pin
oneach rear stroller leg.
3. Locate the small opening on
each rear wheel assembly.
Note:
Attach the rear wheel assemblies to
each stroller leg with the wheel spacer
facing inward.
Attaching & Removing the Front Swivel Wheels
Place front swivel wheel
assembly on the swivel
shaft. The assembly is
secure when it locks onto
the shaft.
Using the Front Swivel Wheels
To lock swivels, push both
swivel lock levers down
To unlock swivels, lift both
swivel lock levers up.
.
Using the Brakes
4. Insert the leg into the wheel
assembly until the small silver
pin locks into the opening.
Removing the Swivel
Wheels
.
up.
-
CAUTION
Push the stroller
forward to
ensure
that the brakes
are properly
engaged.
Press in the square but
ton located at the bottom
of the wheel holder while
pulling the assembly off of
the swivel shaft.
Release Button
To lock brakes,
push both brake
levers down
To unlock
brakes, lift both
brake levers
- 3 -
Attaching the Canopy
CAUTION
Failure to fully secure the canopy holders can cause the holders to
bend. When storing the stroller by laying it down, be sure the cano
py is off the ground to prevent it from bending.
Attaching the Canopy
1. Confirm the canopy is facing in the proper direction.
2. Fully insert the canopy holder (male) to the canopy holder
(female) until a click is heard.
3. Fasten the canopy velcro on both sides around the handles
to the seat back velcro (2 places.)
Removing the Canopy
Pull the velcro apart and squeeze the bottom of the canopy
holder (male). Lift the canopy until it releases from the female
holder.
-
Installing Optional Speakers
1. Insert a speaker into the small
pockets located
on both sides of
the canopy.
2. Place your por
table CD, cassette
or MP3 player inside the
large storage pocket on the
back of the canopy.
3. Attach the speaker cords
through the Velcro holders
on both sides of the storage
pocket.
4. Insert
the
(2.8mm)
plug
into
player.
CAUTION
Be sure to test the volume on your player. Set it at a comfortable
level so that it does not startle your baby when turning it on. Loud
volume can hurt your baby’s ears. If you notice that the sound has
become weak or distorted or if tracks do not change, this is an indi
cation that your batteries are low. Replace the batteries and set the
volume at a comfortable level.
CAUTION
-
Before folding your stroller, be sure to remove your
player from the back pocket of the canopy
This will make it easier to fold the stroller.
When you fold the stroller, you may leave the speakers
in the Acoustic Canopy, but only for short periods of
time.
In the summer, the temperature may get as high as
212°F/100°C or more. Do not leave your stroller, with
the speakers in the Acoustic Canopy pockets, in your
car trunk where the temperature may reach high levels.
Store speakers in a cool and dry area.
.
WARNING:
To avoid serious injury keep stereo
speakers and cords out of reach of
children.
-
Using the Reclining Backrest
1. Press the lever at the top
of the seat to the left.
2. Adjust the backrest gently
to any of three positions.
To return the backrest to the
upright position, simply lift the
backrest gently into place.
WARNING:
Never use seat in reclined position unless the
permanently attached safety cover is used.
CAUTION
Be careful when reclining the backrest while your
baby is in the stroller to prevent abrupt changes
in seating position.
- 4 -
Using the Kid’s Tray
1. Squeeze the Kid’s Tray
release buttons on both
sides to release the Kid’s
Tray.
2. When one side is
released, the Kid’s Tray
will pivot to allow easy
access to the seating
area.
WARNING:
Pull on each side of the Kid’s Tray to make sure that it is
completely attached. Do not lift the stroller by the Kid’s
Tray. To avoid burns, do not carry bottles/cups with hot
liquids.
3. When both sides
are released the
Kid’s Tray can be
removed.
4. To attach the Kid’s
Tray, gently slip it
over the armrest
pins until you hear
the pins click into
position.
Using and Adjusting the 5-Point Harness
1. Place the crotch belt between the baby's legs.
2. Insert both waist belt buckles into the middle plastic piece.
3. Attach each shoulder strap's hook to the top of the waist
belt clips.
4. To adjust the harness or waist
belt, loosen the slack on both
sides of each buckle.
WARNING:
Avoid serious injury from falling or sliding out.
Always use 5-point harness.
WARNING:
Even when the seat belt is fastened, be careful
not to let the child slip out or stand.
- 5 -
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.